Remote Control Operations - GE 20338 User Manual

REMOTE CONTROL OPERATIONS

Operate Fan using Transmitter Code
Pre-Set by Factory
Step 1.
ceiling fan.
Step 2. Install two 1.5-volt
AAA batteries provided.
Step 3. Press the "
located on the front of the
transmitter to operate the fan.
Step 4: Press the "
to operate the light . A dimmer
feature is provided on the light .
Press and release the button
to turn the light ON or OFF.
Press and hold the button to
set the desired brightness.
FAN REVERSE FUNCTION
The reversible motor provides upward and downrod air flow for desired air circulation to save energy, see below for the details.
Warm weather - Switch to the "Forward"
position: A downward air flow creates a
cooling effect as shown. This allows you
to set your air conditioner on a higher
setting without affecting your comfort.
FCC ID: 2AAZPFAN61T3SP1
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.
CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority
to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antena.
rease the separation between the equipment and the receiver.
Operation Instructions
Restore power to
" button
" button
The reverse switch is located on the top
of motor housing. Slide reverse switch to
change fan rotation. Slide the switch to
the left for warm weather operation. Slide
the switch to the right for cool weather
operation.
Note: wait for fan to stop before reversing
the direction of the blade rotation.
rcuit different from that to which the receiver is connected.
TV technician for help.
In Case Of Interference with Several Fans, You Can
Change the Transmitter Code to Operate This Fan
Only.
Step 1.
Step 2.
Step 3.
unlock switch on the back of the
transmitter to lock "
then push the sync "
about 5-10 sec, until the fan light kit
flashes 3 times.
See next page for Remote Functions
Switch off the power of the fan.
Switch on the power of the fan.
Within 30 sec, switch the lock/
" position, and
" button for
Cool weather - Switch to the "Reverse"
position: An upward air flow moves warm
air off the ceiling as shown.This allows you
to set your heating unit on a lower setting
without affecting your comfort.
13