Settings Menu; Station Settings - Toro OSMAC G3 User Manual

Settings Menu

Station Settings

Station Settings allows you to configure each station as an irrigation station or a switch. When a station is
configured as a switch, that station is not affected by the rain delay function. When a switch is activated, it does
not activate the pump terminal.
Step 1 – While at the Home display, press Select
Step 2 – Press DOWN
Step 3 – While Station Settings is selected and press Select
What's Running
Manual Watering
Scheduled Watering
Communication
Diagnostics
Settings
S01 - Select which station you want to edit. While S01 is selected, press Select
arrows to select the station number you want to edit. Press Select
number is displayed.
S01 S01
Disable: No
Is Switch: No
Sched Today None
Water Today None
Water yestr None
Disable - Use this function when you need to disable a station from activation indefinitely. Once disabled,
the station will not activate for all scheduled and manual watering. Watering activity will only resume once the
station's Disable function is set back to No . Use the UP and DOWN
Select . Use the UP and DOWN
SELECT
SELECT
selection is set.
S01
Disable: No Yes
Is Switch: No
Sched Today None
Water Today None
Water yestr None
Is Switch - Set the station to switch when using it to activate a relay or any devices other than the irrigation
system. When the station is set to switch, it is not affected by the rain delay function. The pump terminal will also
not activate when the switch is activated. Use the UP and DOWN
Select . Use the UP and DOWN
SELECT SELECT
selection is set.
Sched Today - Schedule today will indicate if the station is set to a schedule that will irrigate today. This is a
monitor only parameter and can not be modified.
Water Today - Water today will indicate if the station was activated today. This is a monitor only parameter and
can not be modified.
Water Ystr - Water yesterday will indicate if the station performed watering the day before. This is a monitor only
parameter and can not be modified.
until Settings is selected and press Select
Station Settings
Comm Mode: Central
Reset Pgr's: No
Reset Sta's: No
Reset Unit: No
Enable Sta's: No
arrows to select Yes or No . Press Select
arrows to select Yes or No . Press Select
to access the controller menu.
SELECT SELECT
SELECT SELECT
.
SELECT
SELECT
7
.
. Use the UP and DOWN
SELECT
SELECT
when the correct station
SELECT SELECT
arrows to select Disable and press
when the correct
SELECT
SELECT
arrows to select Is Switch and press
when the correct
SELECT SELECT