Comm Mode; What's Running; Diagnostics; Revision - Toro OSMAC G3 User Manual

Comm Mode

- Select this menu to edit the OSMAC G3 controller's communication mode.
Central Mode – When placed in Central mode, the OSMAC G3 satellite will wait and execute radio commands
sent by the central. The satellite will ignore all scheduled watering but will execute manual watering.
Local Mode – When placed in Local mode, the OSMAC G3 will execute scheduled watering as well as manual
watering. Radio commands will be ignored.
Off Mode – When placed in Off mode, the OSMAC G3 will not execute any watering operation whether it is
scheduled or manually initiated. Any watering operation will terminate once the satellite is placed in Off mode.
Watering operations will resume once the satellite is placed back to Central or Local mode.
Step 1 – While at the Home display, press Select
Step 2 – Press DOWN
Step 3 – Press DOWN
Step 4 – Use the UP and DOWN
Step 5 – Press Select

What's Running

Select this menu item to monitor the current watering activity of the OSMAC G3 controller.

Diagnostics

Menu:

Revision

Revision: 1.00
Rev Date: 4/21/16
Menu:

Station Test

Sta: Pump
Press to start
Revision – Displays the firmware's version number and date it was created.
Event Codes – Displays diagnostic codes that the OSMAC G3 controller encountered. The codes could help Toro
troubleshoot your system. Clear the codes by navigating to Clear log , select Yes and press Select
VA Monitor – Displays the real time values of the following:
RDV - Radio Voltage
17V - 17-volt Terminals
LCD - LCD Voltage
Station Test – Utilize this function to test any of the OSMAC G3 controller outputs. You can activate the pump
and any stations by selecting Sta and press Select
output terminal you want to test and press the RIGHT
until you press the LEFT
value.
until Settings is selected and press Select
until Comm Mode is selected and press Select
arrows to select between Central , Local and Off modes.
when the proper mode of operation is set.
SELECT
SELECT
Menu:

Event Codes

Clear log: No
Last code: 02, 002
01/02/16, 17:34:08
Menu: Seq Stations
On each for: 1 sec
Press to start
BV - Battery Voltage
9V - 9-volt Terminals
RSSV - Signal Strength
arrow to turn off. While a station is active, you may test other stations by editing Sta
to access the controller menu.
SELECT
SELECT
SELECT SELECT
Menu:

VA Monitor

RDV: 3.3 BV: 3.2
17V: 18.1 9V: 10.0
LCD: 31 C RSSV: 0.7
Menu: Power Detect
Defaults Set
Detect: 64sta, 00sen
PD 01/07/16 08:00:00
PU 01/01/16 12:00:01
Slot 1 card: Output
. Use the UP and DOWN
SELECT SELECT
arrow to activate. The station will remain activated
16
.
.
SELECT SELECT
arrows to select the
.
SELECT
SELECT