14.3.2.9 Type Modbus
14.3.2.9.1 Selection and activation of the sensor type
First step: select a free sensor channel
Main menu Settings Sensor settings A1
Second step: select the Modbus type
Main menu Settings Sensor settings A1 Type text field Modbus
Third step: confirm with
Now, a
name
(see Chapter
Main menu Settings Sensor settings A1 Right arrow (2
14.3.2.9.2 Modbus settings
Main menu Settings Sensor settings A1 Right arrow (2
text field
Main menu Settings Sensor settings A1 Reg. address text field
54
OK
12.2.2.7 Marking and setting text
Operation METPOINT® BDL compact
fields) can be entered.
page) VA Use
nd
Via Modbus, up to eight registry values
(from input or holding registers) of the sen-
sor can be read out.
Selection via the register tabs
activation by means of the respective
button.
page) Modbus settings ID
nd
Here the
Modbus ID
is entered which is deter-
mined for the sensor, permissible values are
247, (ex. here
Modbus ID = 12)
In addition, the serial transmission settings
rate, stop bit, parity bit, and timeout time
be defined.
When the BDL compact is connected to the end of
the bus, the termination can be activated via the
Term
button, or a BIAS energised via the
ton.
Confirmation with
OK.
Resetting to the initial settings by means of the
to default button.
Please refer to the data sheet of the sensor for the
setting of the Modbus ID and the transmission set-
tings.
Va –Vh
and
use
1 –
baud
need to
Bias
but-
set
METPOINT® BDL compact