Related Manuals for Mercedes-Benz Wallbox Home
Summary of Contents for Mercedes-Benz Wallbox Home
- Page 1 Mercedes-Benz Wallbox Home Installation manual for specialist electrical contractors...
-
Page 2: Important Addresses
Mercedesstraße 137 70327 Stuttgart, Germany For technical issues, please contact your local Mercedes-Benz technical support. This manual, in its entirety or in parts, must not be reproduced, stored electronically or otherwise transmitted electronically, electrically, mechanically, optically, chemically, by photocopy or as an audio recording without express written permission. -
Page 3: Table Of Contents
Returning your Wallbox Unpacking and components Appendix included Technical specifications Identifying your model variant Scale drawings and dimensions Structure of the Mercedes-Benz Wiring sequence Type 2 Wallbox Home Guidelines & Norms Preparations, installation and CE certification and compliance taking into operation... -
Page 5: Important Information
The Mercedes-Benz Wallbox Home model variants can be clearly identified by the product label: These labels state the Mer- cedes-Benz product identification number (exterior underside) as well as the ABL model number (inside of interior electronic components cover), but are identical with regards to technical specifications. -
Page 6: Safety Notices On The Device
Only use accessories intended and sold for the device by Mercedes-Benz. • Do not install this Wallbox in close vicinity to running water or water jets: The Mercedes-Benz Wallbox Home is protected • against water entering the device according to IP 55. -
Page 7: General Product Information
Should a malfunction occur with your Wallbox, please first read the sections regarding “Error detection and solutions” on page 18. Should the fault or malfunction recur and still not be able to be resolved, please contact your local Mercedes-Benz technical support. -
Page 8: Notes Regarding Installation
At all times comply with local safety regulations for the country in which you operate the Wallbox. • For proper operation, the power supply for the Mercedes-Benz Wallbox Home must be protected in the domestic power • supply with an MCB (rated current depending on power supply and Wallbox settings, but no more than 32 A) that is not followed by any other downstream electrical devices. -
Page 9: Introducing The Product
LED without having to open the housing of the Wallbox. After being taken into operation by a specialist contractor, the Mercedes-Benz Wallbox Home is ready for charging at any time, while each charging process must be separately authorized via the integrated key switch. -
Page 10: Structure Of The Mercedes-Benz
Should your Wallbox model variant not be described in this manual, please contact your local Mercedes-Benz technical support: Do not under any circumstances install the Wallbox in this case, as this could lead to damage to the Wallbox, and to potentially fatal injury. - Page 11 This opening is used to fix the electronic components cover to the housing base with a fixing screw (M4 x 10). RCCB (residual current circuit breaker) access flap This flap provides access to the internal RCCB of the Wallbox. Lens for multi-colored LED display The multi-colored LED display is shown through this lens. Mercedes-Benz Wallbox Home | Introducing the product...
- Page 12 These grommets seal the openings for data cables in the terminals area of the housing base. Connecting data cables is pos- sible e.g. in conjunction with a Mercedes-Benz Wallbox Advanced. Please see the relevant information on connections in the installation manual for the Mercedes-Benz Wallbox Advanced, available at: www.yourwallbox.de/downloads/Mercedes-Benz/Advanced/...
-
Page 13: Preparations, Installation And Taking Into Operation
General requirements of the installation site Your Mercedes-Benz Wallbox Home is an electrical device and is therefore subject to particular requirements for indoor and outdoor installation. In selecting the installation site, you must consider the following points: Observe all local regulations for electrical installations, e.g. regarding fire protection and accident prevention. -
Page 14: Mechanical And Electrical Installation
Depending on the desired rated power, the installation of the Wallbox may need to be registered with and/or approved by • the local electricity grid operator before the device is taken into operation. Please consult the regulations of your local electricity grid operator. -
Page 15: Mercedes-Benz Wallbox Home
Note: Protect the housing cover from scratches and other types of exter- nal damage. Only remove the protective film from the housing cover as your last step, immediately before completing installation. Mercedes-Benz Wallbox Home | Preparations, installation and taking into operation... -
Page 16: Mercedes-Benz Wallbox Home
4. The Mercedes-Benz Wallbox Home is now preinstalled at the installation site. 9. Using the TX30 screwdriver, fix the housing base in place by inserting the... - Page 17 In case of an unbalanced load on the supply grid, please observe the technical requirements for installation in force lo- cally. The Mercedes-Benz Wallbox Home is equipped with a symmetry monitoring function that can be activated using the coded rotary switch. Please find additional information in section “Setup and test modes” on page 15.
-
Page 18: Taking The Wallbox Into Operation
When the Wallbox is connected to the electricity grid, it will initiate the start-up procedure: This includes a test of the internal electronic components to ensure correct functioning. The internal check routine is indicated by the LED display on the front of the Mercedes-Benz Wallbox Home as follows. LED display Description The LED flashes white once ... -
Page 19: Setup And Test Modes
If no vehicle is available for taking the Wallbox into operation or for testing it, you can check the functioning of the Mercedes- Benz Wallbox Home (contactor, CP and RCD tripping) using test mode. You can also alter the factory setting for the maximum charging current of the Mercedes-Benz Wallbox Home in setup mode using the coded rotary switch if the charge current made available by the domestic power supply differs from this preset value. - Page 20 11. During start-up, the Wallbox will upload the setting of the coded rotary switch and then work using the charging current set by the switch. Setup mode Please follow these steps to change the maximum charging current setting of your Mercedes-Benz Wallbox Home: Working step Status of LED display 1.
- Page 21 32 A with 20 A imbalance detection no function Measuring voltage (contactor closed) and communications (CP) possible at the charging contacts in order Test mode to test functionality without a vehicle Normal operations Factory setting Mercedes-Benz Wallbox Home | Preparations, installation and taking into operation...
-
Page 22: Error Detection And Solutions
Operational malfunctions and solutions For safe operation, the Mercedes-Benz Wallbox Home must be protected by an MCB in the domestic power supply in addition to the internal RCCB. To take suitable measures and restore operation in case of malfunction, you must first clearly identify the type of error. -
Page 23: Error Codes And Solutions
If this error repeats or persists, an internal malfunction has occurred and the Wallbox must be replaced. Take the Wallbox out of operation (see “Taking the product out of and back into operation” on page 22) and contact your local Mercedes-Benz technical support. - Page 24 If the error repeats or persists, the Wallbox must be cooled and/or shaded more effectively at the installation site. If the error repeats or persists, the Wallbox must be checked and replaced if required: Contact your local Mercedes-Benz technical support.
-
Page 25: Checking The Internal Rccb
Wallbox must be replaced. Take the Wallbox out of operation (see “Taking the product out of and back into operation” on page 22) and switch off the upstream MCB. Contact your local Mercedes-Benz technical support. -
Page 26: Taking The Product Out Of And
3. Always observe the five golden rules of electrical installation! Now, no charging procedure can be carried out with the Mercedes-Benz Wallbox Home and it can be uninstalled by a qualified electrical contractor if required. If you do not want to uninstall the Wallbox, replace the housing cover by hooking it onto the upper edge of the housing base and lock it using the key provided. -
Page 27: Appendix
438 x 328 x 170 mm (H x W x D) Maximum elevation ≤ 2,000 m AMSL (above mean sea level) Weight per unit (net) ca. 8.5 kg Weight per unit (gross) ca. 10 kg Mercedes-Benz Wallbox Home | Appendix... -
Page 28: Scale Drawings And Dimensions
Scale drawings and dimensions The Mercedes-Benz Wallbox Home is delivered fully assembled and checked. The following scale drawings show the housing dimensions as well as the distances for the screw slots required for installation. Wall box with fixed charging cable... -
Page 29: Wiring Sequence Type 2
Wiring sequence Type 2 L2/N Guidelines & Norms The Mercedes-Benz Wallbox Home complies with the following standards and protection ratings: General guidelines and laws Guideline Explanation 2014/35/EU Low voltage directive 2014/30/EU EMC Guideline 2011/65/EU RoHS 2 guideline 2012/19/EU WEEE Guideline... -
Page 30: Ce Certification And Compliance Declaration
IP 55 against light water jets from any angle (DIN EN 60529: 2014-09) CE certification and compliance declaration The Mercedes-Benz Wallbox Home carries the CE mark. The associated declaration of compliance is available for download in electronic format at www.yourwallbox.de/downloads/documents/Declaration_of_Conformity_Home_Advanced.pdf. -
Page 31: Intellectual Property & Copyright
European Union: please inquire with your local authorities regarding proper disposal. The materials are recyclable as marked. By re-using, recycling or through other forms of processing obsolete devices, you make an important contribution to environmental protection. Mercedes-Benz Wallbox Home | Appendix... -
Page 32: Mains Connection Schemes
Mains Connection Schemes Local Local voltage Country Phase L1 Phase L2 Phase L3 Neutral 1-ph 3-ph frequency (domestic applications) Albania 50 Hz 230 / 400 V Argentina 50 Hz 220 / 380 V Australia 50 Hz 230 / 400 V Azerbaijan 50 Hz 230 / 400 V Bahrain 50 Hz 230 / 400 V 110 / 220 V... - Page 33 220 / 380 V Local Local voltage Region Country Phase L1 Phase L2 Phase L3 Neutral 1-ph 3-ph frequency (domestic applications) Europe 50 Hz 230 / 400 V (without Norway and UK) 110 V Norway 50 Hz 230 / 400 V 50 Hz 240 / 415 V Mercedes-Benz Wallbox Home...
- Page 34 The manufacturer may have made minor technical modifications to the product after publication of this operating manual. This may also have led to minor discrepancies in the appearance of the product. Any color differences are a result of the printing process. Daimler AG, Mercedesstr.
Need help?
Do you have a question about the Wallbox Home and is the answer not in the manual?
Questions and answers