Advertisement
STACKING INSTRUCTIONS
Note: Every DXST4500 Industrial Rack comes with two (2)
stacking plates. In order to safely stack two of these racks
together, you MUST use four (4) of these plates.
It is recommended that one person holds the upright frames in
place while a second person installs the stacking plates.
STEP 1
•
Assemble the second set of upright frames by following the
instructions on Page 8.
STEP 2
•
Using a screwdriver and rubber mallet, remove all four
black caps from the bottom of the newly assembled
upright frames. This will now become the top rack. Remove
all four black caps from the top of the fully assembled rack.
This will now become the bottom rack.
STEP 3
•
Line up and place an upright frame on top of one side of
the fully assembled rack. Be sure the hole patterns are
going in the same direction. The stacking brackets feature
a top and bottom set of locking tabs. Engage the top set
of tabs into the very bottom of the vertical beam and the
bottom set of locking tabs into the very top of the upright
frame. Use the same downward motion to attach these
brackets as you did for the crossbeams. The locking pin
holes on the bracket should be at the bottom. Repeat for
the remaining three stacking brackets.
STEP 4
•
Insert the locking shelf pins into the open pin holes on
the brackets.
Assemble the remaining pieces of the top rack by following
the instructions detailed on Pages 8-12.
WARNING!
• Serious injury or death can occur from furniture tipping over.
To prevent this, the rack must be secured to a wall, especially
in earthquake-prone areas or where surfaces are uneven, and
where children and/or pets are present.
TOP RACK
VERTICAL
BEAM
UPRIGHT
FRAME
BOTTOM RACK
13
Hide quick links:
Advertisement
