Loading My First Psoc Project - Cypress CY8CKIT-001 Manual

2.

Loading My First PSoC Project

The CY8CKIT-001 PSoC Development Kit supports projects across the PSoC 1, PSoC 3, and
PSoC 5 architectures. This section walks you through the high-level design process for opening,
building, programming, and running your first PSoC project using this kit.
Before beginning, follow each of these steps to make certain that your software and hardware
environments are properly configured and ready for these projects:
1. Install PSoC Designer using the steps listed in
page 8.
2. Install PSoC Creator using the steps listed in
3. Connect the MiniProg3 into your PC using the supplied USB cable. When you connect the
MiniProg3, Microsoft Windows
are installed as part of the PSoC Programmer installation process; however, if Windows opens
the driver installation dialog boxes, accept the defaults and allow Windows to automatically find
the appropriate driver.
4. Close any open PSoC Creator or PSoC Designer applications and projects.
5. Configure the PSoC development board (jumper settings and switches) in its default configura-
tion, as described in
6. Use the PSoC CY8C28 family processor module or PSoC CY8C29 family processor module for
the PSoC 1 version of your first PSoC project
My First PSoC 1 (CY8C29) Project on page
7. Use the PSoC CY8C38 family processor module for the PSoC 3 version of your first PSoC
project (My First PSoC 3 (CY8C38) Project on page
8. Use the PSoC CY8C55 family processor module for the PSoC 5 version of your first PSoC
project (My First PSoC 5 (CY8C55) Project on page
9. For a PSoC 1 project, use the ISSP header on the PSoC CY8C28 family processor module or
PSoC CY8C29 family processor module and connect the MiniProg3 ISSP port.
10.For a PSoC 3 or PSoC 5 project, use the JTAG ribbon cable. Connect the ribbon cable to the
MiniProg3 and the CY8C38 family processor module or CY8C55 family processor module into
the header labeled PROG on the processor module.
Note The MiniProg3 should not be "hot plugged" into processor modules that are attached to the
PSoC development board. In other words, do not plug the ribbon cable of the MiniProg3 into the
processor module while code is actively running on the module. Doing so may cause the PSoC
device to unintentionally reset. Power down the PSoC development board and module by
unplugging the power supply from the development board before attaching the MiniProg3 device
to the module board. When the ribbon cable is attached to the module board, power the system
by plugging in the power supply to the PSoC development board. This will avoid any undesirable
PSoC device resets.
11. Power the PSoC development board using the 12-V AC power supply adapter.
CY8CKIT-001 PSoC Development Kit Guide, Doc. # 001-48651 Rev. *J
®
may indicate that it has found new hardware. All required drivers
Default Switch and Jumper Settings on page
Installing PSoC 1 Development Software on
Installing PSoC 3 Development Software on page
10.
(My First PSoC 1 (CY8C28) Project on page 16
20).
25).
28).
8.
or
15