Hitachi HA8000 Series User Manual page 12

12
1 Push slightly the lock of the twisted pair cable's connector and insert the cable into the connector
of the LAN Card until it locks.
2 Push slightly the connector lock at the other end of the twisted pair cable and insert the cable into
the connector of the hub until it locks.
When connecting the LAN cable to the network interface connector, pay
attention to the following. If you handle the cable improperly, it may cause
the network interface connector to break.
■ Use the TIA/EIA-568 compliant cables of UTP (unshielded twisted pair)
Category 3, Category 4, Category 5, or Enhanced Category 5.
■ For the network interface connector of the LAN cable, use an
RJ-45/ISO8877 compliant connector.
■ Lay the LAN cable so that it may not give stress to the network
interface connector.
■ When removing the LAN cable, push the hooks of the cable connector
and pull the cable straight out.
Twisted pair cable
Cable length: Max 100m