Advertisement
Y
PARTS INCLUDED:
Work Surface
Pin (2)
TOOLS REQUIRED:
3/16 Hex Socket
1
Place the work surface on a clean flat surface.
Z
© 2011 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, and Z are among the registered trademarks of Herman MIller, Inc.
TM
Envelop is among the trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
Left Support
Cap Screw (4)
Button Head
Cap Screw (4)
Ratchet
Envelop
Right Support
Completed Views of Envelop
Assembly
2
Shaft
Pin
For each tube, place a pin into the pin hole.
Make sure the flat side is pointing up as
shown in the figures above.
™
Assembly Instructions
Tube (2)
Part no. 1b5j77 rev B.
1
Advertisement
Table of Contents
Related Manuals for HermanMiller Envelop
Summary of Contents for HermanMiller Envelop
-
Page 1: Tools Required
© 2011 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A. ® Y, and Z are among the registered trademarks of Herman MIller, Inc. Envelop is among the trademarks of Herman Miller, Inc. Illustrations and specifications are based on the latest product information available at the time of publication. - Page 2 © 2011 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A. ® Y, and Z are among the registered trademarks of Herman MIller, Inc. Envelop is among the trademarks of Herman Miller, Inc. Illustrations and specifications are based on the latest product information available at the time of publication.
Need help?
Do you have a question about the Envelop and is the answer not in the manual?
Questions and answers