Samsung SW-232 User Manual
Samsung SW-232 User Manual

Samsung SW-232 User Manual

Cd-r/rw drive
Hide thumbs Also See for SW-232:

Advertisement

Quick Links

CD-R/RW DRIVE
SW-232
User's Guide
FCC Compliance
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be deter-mined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
Re-orient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

Advertisement

Table of Contents
loading

Summary of Contents for Samsung SW-232

  • Page 1 CD-R/RW DRIVE SW-232 User's Guide FCC Compliance This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
  • Page 2: Table Of Contents

    Do not attempt to repair the CD-R/RW drive yourself. CAUTION Contact your dealer or local SAMSUNG representative for all repairs. If you make any adjustments or perform any operations other than those specified in this guide, you run the risk of exposure to hazardous radiation.
  • Page 3: Your Cd-R/Rw Drive

    Your CD-R/RW Drive 1. Connector for stereo headphones with a 3.6 mm stereo mini-jack. 2. Headphone volume control. 3. Emergency eject hole. (if the compartment does not open when you press the Eject button, power off the computer, insert a pin or unfolded paper clip in the hole and push firmly) 4.
  • Page 4: Installing The Cd-R/Rw Drive

    Installing the CD-R/RW Drive To install your CD-R/RW drive in the PC, proceed as follows. Make sure that the PC is powered off and disconnected from any power source. If necessary, attach a horizontal bracket to both sides of the drive. Use of the brackets depends on your computer model;...
  • Page 5: Installing The Cd Record Utility

    The SAMSUNG CD-R/RW SW - *** device name is displayed. The SAMSUNG device driver enables discs in the CD-R/RW drive to be read but not recorded in an MS-DOS environment; the driver is located in the D driver folder on the CD record utility disc.
  • Page 6: Setting Up The Device Driver

    Manual Setup Make the C:\SAMSUNG directory. Copy the files from the diskette to the C:\SAMSUNG directory. To do so, type COPY A: * . * C:\SAMSUNG after the C:\prompt and press [Enter]. Edit the CONFIG.SYS file. Add the DEVICE=C:\SAMSUNG\SSCDROM.SYS \D:SSCD000/V entry.
  • Page 7: Solving Recording Problems

    Solving Recording Problems If you have any problems recording via your CD-R/RW drive, follow the appropriate instructions below for the source that you are using. Hard Drive Check whether the source file is corrupted. Optimize the hard disk by using the Windows defragmenter feature: START / PROGRAMS / ACCESSORIES / SYSTEM TOOLS / DISC DEFRAGMENTER Decompress the hard disk if it is compressed.
  • Page 8: Recommended Disc Types

    The CD-R/RW drive is not Reinstall the device driver or update it with the latest version by downloading it from the recognized by MS-DOS. Samsung Web site. - www.samsungodd.com - www.samsungelectronics.com The CD-R/RW drive is not This case may occur when there is a Windows installation problem;...
  • Page 9: Technical Specifications

    CD but a form of image file. In this case, select a recorder from the menu items at the upper part of NERO and then select SW-232 from the Recorder Selection window. When installing the recording software, try not to install the software before the ROM drive as this makes the Image Recorder selected.

This manual is also suitable for:

Sw-232b

Table of Contents