Cleaning The Drain Filter; Preventing A Frozen Water Supply Hose; Cleaning The Filter Net Of The Water Supply Hose - Kenwood K10W7D18 Installation Instructions Manual

cleaning the drain filter

Be careful not to burn yourself while cleaning the drain filter. Water draining from
the filter compartment may be hot after a high temperature wash.
Before cleaning the drain filter, switch off and unplug the machine.
1. Open the service panel. Place a suitable container under the service panel to catch the water.
2. Rotate emergency drain hose cap and pull out the emergency hose. Take off the cap and let the
water drain. After the water has drained, replace cap and return hose to original position. Screw
the emergency drain hose cap back into place.
3. Carefully loosen the drain filter anti-clockwise. Water may drain out - this is normal.
4. Unscrew the filter to remove it.
5. Remove any lint and debris before carefully replacing the filter.
6. Turn the filter clockwise to screw back into place. Close the service panel.

preventing a frozen water supply hose

If your machine is delivered in freezing weather conditions, leave it at
room temperature for 24 hours after you've set it up before using it. This
ensures there's no ice blocking the water supply hose. If your water
supply hose freezes, add 2 or 3 litres of warm water to the drum. Then
run "Express" programme without detergent.

cleaning the filter net of the water supply hose

1. Turn the water supply off at the tap.
2. Remove the water supply hose from the tap.
3. Manually remove the filter net located on the tap side of the water supply hose and clean using
a small brush (e.g. a toothbrush).
4. Return the filter net to its original position.
5. Re-connect the water supply hose to the tap and turn the tap back on, checking for leaks.
24
Emergency
drain hose
about
50°C