Table of Contents
Advertisement
installation
moving and installing
removing the transit bolts
Four transit bolts keep the interior of the machine in place while it's being moved.
They need to be removed before installation. Use a spanner (not supplied) and follow the
instructions detailed below.
Don't run the machine without removing the transit bolts, as this can cause excessive
vibrations and may damage your machine.
To remove the transit bolts:
1. Use a spanner to loosen the four bolts. They are located at the rear of the machine.
2. Pull the bolts out horizontally. Make sure the entire bolt is removed.
3. Push the four bolt covers (included with your accessories) into the respective bolt holes.
You'll need the transit bolts again if you move the machine, so make sure you keep
them in a safe place.
moving the washer dryer from one location to another
Before you move the machine:
•
Shut off the tap and run the machine to drain the water. Drain any remaining water from the
pump hose.
•
Disconnect the mains cable.
•
Attach the transit bolts.
Make sure to fix the transit bolts prior to moving the machine.
10
Hide quick links:
Advertisement
Table of Contents
