Specifications; Installing The Batteries; Fcc Statement - Honeywell ADEMCO 5804 Installation And Setup Manual

SPECIFICATIONS

Transmission Frequency: 345MHz
Unit Dimensions: 2-1/4"W (57mm) x 1-1/2" H
(38mm) x 0.5"D (12.7mm)
+ POS. end
must face down
+ POS. end
must face down

INSTALLING THE BATTERIES

Battery: Use only Duracell DL2025 or ADEMCO
supplied batteries.
Battery Access:
1. Put the alarm system into the TEST mode by
entering your user code plus the number 5
(TEST) on the keypad. While the alarm system is
in the TEST mode, the keypad will beep every 30
seconds.
FCC ID: CFS8DL5804
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
including interference that may cause undesired operation.
FOR WARRANTY INFORMATION, AND FOR DETAILS REGARDING THE LIMITATIONS OF THE ENTIRE ALARM
SYSTEM, REFER TO THE INSTALLATION INSTRUCTIONS FOR THE RECEIVER/CONTROL WITH WHICH THIS
DEVICE IS USED.
165 Eileen Way, Syosset, New York 11791
ÊN7674V2pŠ
N7674V2 5/04 Rev. A
WWW.DIYALARMFORUM.COM
2. Remove case back by inserting the blade of a
3. Remove the existing batteries by prying them out
4. Push new batteries into case back locations (see
5. Close by snapping case front and back together.
6. Exit the alarm system TEST mode by entering
Important Note: Do not remove Printed Circuit
Board.

FCC STATEMENT

CANADA: 1748101619 5 3
(2) This device must accept any interference received,
Copyright © 2004 Honeywell International Inc.
www.honeywell.com/security
small screwdriver into the seam around the case
and prying the case open.
with a small screwdriver.
diagram). The + POS side must face down.
your user code plus the number 1 (OFF).
Figure 2. Battery tabs shown
Blue
Red
Figure 3. 5804 shown open,
buttons facing down.