Flush Cooling System And Changing Coolant(Aj); Flush Cooling System And Changing Coolant(Aj) - Kioti PX1002 Owner's Manual

flUsh COOlING sysTEM AND ChANGING COOlANT(AJ)

(1) Drain cock
1. stop the engine and let it cool.
2. To drain the coolant, open the radi-
ator drain cock and remove radia-
tor cap. The radiator cap must be
removed to completely drain the
coolant.
3. after all coolant is drained, close
the drain cock.
4. fill with clean water and cooling
system cleaner.
5. follow the cleaner manufacture's
instruction.
TG110-AU-07.indd 33
Tg1o754a
(1) radiator cap
(a) full
6. install the radiator cap securely.
7. start and operate the engine for
few minutes.
8. stop the engine and let it cool.
9. Drain water and clears.
10. add coolant and water, run for a
few minutes and allow to come
up to temperature.
11. stop engine and let cool.
12. check coolant level of reservoir
tank and radiator. add coolant if
necessary.
To avoid accidents :
•
D o n o t r e m o v e t h e r a d i a -
tor cap while the coolant is
hot. you can get burnt by hot
steam. Make sure to remove
Tg1o765a
it after the coolant is cooled
(2) reservoir Tank down enough.
(B) low
•
Even though the coolant is
cooled down, turn the cap to
its first stop and then wait un-
til it is depressurized before
removing the cap completely.
7
MainTenance
Coolant capacity
13.9 l (3.7 u.s.gal.)
CAUTION
2013-03-15 오후 5:11:50
33
-
7