Related Manuals for Target 4273
Summary of Contents for Target 4273
- Page 1 6-Cube Organizer style dpci finish 4273 002-11-0501 Avington 4279 002-11-0746 White 4290 002-11-0789 Weathered Gray 4301 002-11-1221 Natural >> assembly instructions...
-
Page 2: Introduction
Congratulations on your latest Target purchase. Now what? Don’t start sweating over this box of parts. This will be easy. We did the hard work for you. All you need to do is follow our simple instructions and you’ll be on your way to transforming your room in no time. -
Page 3: Table Of Contents
table of contents introduction hardware parts list safety precautions installing L-bracket assembly 8-12 additional accessories weight capacity/care instructions QUESTIONS? Just call 1-800-874-0008 for parts and service. For faster service, have the style number and DPCI number ready when calling. -
Page 4: Hardware
hardware (H1) x 16 pre-glued dowel (H2) x 8 hex screw (H4) x 2 (H3) x 2 (H5) x 2 wall screw L-bracket screw L-bracket #10 x 1/2” #10 x 1-1/2”... -
Page 5: Parts List
ITEM DESCRIPTION QUANTITY side panel top/bottom panel divider fixed shelf... -
Page 6: Safety Precautions
safety precautions warning • This unit contains small parts which could be a choking hazard for small children. Children should be under adult supervision at all times or serious injury could occur. • Always unload unit prior to moving the unit. The weight of personal belongings can cause the unit to become unstable and either tip or collapse. Serious bodily injury and/or damage to personal belongings may occur. -
Page 7: Installing L-Bracket
installing L-bracket There are several "key points" to L- Secure L-bracket on the inside of panel A. See step 5 bracket installation. Please for detailed installation instructions. review the drawings and comments at right as well as the assembly steps provided. panel B All units must be fastened to the wall. -
Page 8: Assembly
step 1. (H1) (H1) x 16 pre-glued dowel 1. Arrange fixed shelf (D) and dividers (C) as shown. 2. Quickly dip pre-glued dowels into a cup of water, making sure entire dowel gets wet. 3. Immediately push dowels into holes on unfinished edges of each panel. Two dividers will only have two dowels on one side. - Page 9 step 2. 1. Align dowels on dividers (C) with center holes on fixed shelf (D) as shown. 2. Push dividers into place. Dowels in dividers (C) should interlock with dividers (C) on other side of fixed shelf (D).
- Page 10 step 3. 1. Align dowels on dividers (C) with center holes on both top/bottom panels (B). 2. Push top/bottom panels into place.
- Page 11 step 4. (H2) (H2) (H2) (H2) (H2) (H2) (H2) x 8 (H2) hex screw (H2) 1. Align screw holes in top and bottom panel (B) with screw holes in both side panels (A). 2. Secure top and bottom panels (B) to both side panels (A) using four hex screws for each panel. Tighten screws using supplied hex wrench.
- Page 12 step 5. warning All units MUST be fastened to the wall. L-bracket must be mounted no more than 1 1/2 inches from edge of panel. panel A (H4) 1 in. (H3) panel B wall stud (H3) x 2 (H4) x 2 (H5) x 2 L-bracket screw wall screw...
-
Page 13: Additional Accessories
additional accessories - purchased separately USE 2 SETS WITH ORIENTATIONS SHOWN BELOW CASTERS DO NOT USE WITH ORIENTATIONS SHOWN BELOW USE 3 SETS WITH ORIENTATIONS SHOWN BELOW USE 2 SETS WITH ORIENTATIONS SHOWN BELOW FEET USE 3 SETS WITH ORIENTATIONS SHOWN BELOW... -
Page 14: Weight Capacity/Care Instructions
weight capacity/care instructions warning 55 lbs. This unit has been designed for the weight shown. Exceeding this recommended weight could result in excessive "sagging" of the top or shelves. Extreme overloading can cause failure of the unit and possible injury. Care Instructions: Dust with a clean, lint-free dry cloth. - Page 16 © 2018 Target. The Bullseye Design is a trademark of Target Brands, Inc. All rights reserved.
Need help?
Do you have a question about the 4273 and is the answer not in the manual?
Questions and answers