Table of Contents
Advertisement
Preparing the Machine for Use
Once automatic correction is complete, remove the detection pin and the automatic
correction jig.
To remove the automatic correction jig, turn the screws securing the automatic correction jig about 3
times, and then pull out the automatic correction jig while pushing down on its screw heads.(
tach the automatic correction jig." step
Store the detection pin and the automatic correction jig in the storage compartment.
42
)
to
Click the [Maintenance] tab.
Click [Automatic correction].
Make sure that the work displayed on the
screen is complete.
Click [OK].
Automatic correction starts.
Automatic correction is complete once the screen in
the figure is displayed.
Click [OK].
P. 40"At-
Advertisement
Table of Contents
Need help?
Do you have a question about the DWX-51D and is the answer not in the manual?
Questions and answers