Table of Contents
Advertisement
Chapter 1: Introduction
Physical Details
Doorbell/WPS
This button has two functions:
Button
1. WPS Pin Code Mode. When pressed and held for
Note: When WiFi connection is established, the WPS
function is disabled.
2. Doorbell. Press the button to ring the bell.
LED Behavior
z
z
z
z
z
z
z
4
0-10 seconds, the doorbell camera will be in the
WPS Pin Code mode.
Off - No power.
On (Blue) - Power On / Network connection is
available.
Blinking (Green). The WPS connection is active.
On (Red) - If the LED is on for 5 seconds and
then turns off, the WPS function has failed.
Blinking (Red) - Network connection is failed.
Spinning (Green). The firmware is being
upgraded.
Intermittent Blinking (Red) – If the LED is
blinking for 2 seconds, means AC power is
disconnected.
DBC835 Wireless Doorbell Camera Installation
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the DBC835 and is the answer not in the manual?
Questions and answers
How do I get my camera in doorbell to change to my new WiFi that I changed to. Light shows green. Have reset it 3 times alreadyEverything else is online.
To connect your ADT Pulse DBC835 doorbell camera to a new WiFi network, follow these steps:
1. Power up the camera and wait for the LED to start flashing red.
2. Access the ADT Pulse portal or TS Installer app:
- Open an Internet browser and log in to the Pulse portal.
- Go to the "System" tab and click "Manage Devices."
- Click on "Cameras."
3. Use WPS with PIN to connect:
- Press and hold the Doorbell/WPS button for 0-10 seconds to enter WPS Pin Code mode.
- Follow the on-screen instructions in the Pulse portal or TS Installer app to enter the PIN and complete the connection.
4. Verify the connection:
- A solid blue LED indicates a successful connection.
- If the LED blinks red, the network connection has failed, and you should retry the steps.
Make sure your WiFi network is active and within range of the doorbell camera.
This answer is automatically generated
Ring doorbell is connected, lights are green. How do I make it the pictures.
You can view pictures from the ADT Pulse DBC835 Doorbell Camera on your smartphone, tablet, or ADT Pulse Portal. The camera delivers 720P HD resolution, allowing you to see who is at your door through these devices.
This answer is automatically generated