Erasing A Single User From The Memory - Et DRIVE 1000 Installer's Instructions

Receiver programming and setup.

Erasing a single user from the memory.

From Standby status
Action
To enter the program
menu. Press and hold the
 button until buzzer
beeps.
Scroll < or > to select the
receiver setup option.
With "Receiver Setup"
on the display, press and
release .
Scroll < or > to select the
Erase remotes option.
With "Erase remotes"
on the display, press and
release .
With "Select Address"
on the display, press and
release .
Scroll < or > to the user
address that you would like
to erase.
With the correct user
address displayed, press
and release .
After the display confirms
the erasing of the address
is done.
Repeat the last 4 steps here to erase additional users or exit back one level in the receiver setup menu for other receiver setup options.
Scroll left or right to next
program option.
- "Selected" mode -
Description
Display and buzzer
confirms.
Display scrolls
through options.
Display shows current
option status.
Display scrolls
through options.
Display shows first
erase option.
Processor scans the
memory and then
displays the first
available user address
that can be erased.
Display scrolls
through available
user addresses.
Display confirms the
user address has
been erased.
Display reverts to
Erase Remotes
main erase remotes
Erase done
options.
The gate can be in any position when performing this routine.
- Standby
Display
Programming menu
<or> for options
Receiver Setup
<  = change >
Receiver Setup
Quick learn
Receiver Setup
Erase remotes
Erase Remotes
Select Address
Erase Address
< 1
Erase Address
< 5
Erase Remotes
Erase done
Erase Remotes
Select Address
EXIT back to standby
OR
status
25
Receiver Setup
Response
Buzzer
x2
x1
>
>
x2
Gate
"Selected" mode
- Standby