Water Maintenance And Chemicals - mspa M-009LS Alpine Owner's Manual And Warranty

● The air bubble function is activated when heater is on
● The spa is not properly covered with the spa cover when heater is on
ERROR CODE CHART
LED READING
Water temperature is lower than zero degree
or exceed 55°C(131°F)
E0
Temperature sensor failure.
Water pressure switch failure
E1
Filter failure
Water level is not at minimum water line
Detecting function failure
E2
No water in the spa tub
E3 System failure
WATER MAINTAINCE AND CHEMICALS
Water Sanitation
The spa owner must regularly check and keep the spa water sanitized with scheduled maintenance (daily, if
necessary). Adding sanitizer or other chemical will control bacteria and viruses present in the spa water. The
maintenance of a proper water balance through appropriate use of sanitizers is the most important factor in
maximizing the life and appearance of the spa as well as ensuring clean, healthy and safe water.
Proper technique is important for water testing and treating the spa water. See your spa professional for
chemical, sanitizer, test kit and testing procedures questions.
CAUSE
17
SOLUTION
Change the water or contact the
MSpa Service Center.
Contact the MSpa Service Center.
Add more water to the minimum line.
Contact the MSpa Service Center.
Add more water to the minimum line.
System self-checking
Step 1: Fill water to the water line, and
make sure there is no bather or
object in the spa tub.
Step 2: Connect the power supply, press
REST button on the PRCD.
Step 3: If E3 shows, contact the MSpa
Service Center. If E3 is flashing,
press ON/OFF and BUBBLE
buttons together, enter to the
self-checking system.If no error
code shows, failure is not detected.
It is OK to use the spa. If error
code shows after self-checking,
contact the MSpa Service.