Toro VR-2650 Operator's Manual page 4

Operation
•
Never run an engine in an enclosed area.
•
Only operate in good light, keeping away from holes and
hidden hazards.
•
Use care when loading or unloading the machine into a
trailer or truck.
•
Never lift the machine on your own. Make sure to have at
least two persons to lift the machine.
•
Be sure that all drives are in the slow position before
starting the engine. Start the engine from the operator's
position only.
•
Do not change the engine governor setting or overspeed
the engine.
•
Keep hands and feet away from the shoe of the
compactor.
•
Look behind and down before backing up to be sure of
a clear path.
•
Do not operate the machine under the influence of
alcohol or drugs.
•
Use care when approaching blind corners or objects that
may obscure vision.
•
Ensure that the area is clear of other people before
operating the machine. Stop the machine if anyone enters
the area.
•
Never leave a running machine unattended. Always stop
the engine and verify that the compacting shoe has been
completely stopped.
•
Never jerk the controls; use a steady motion.
•
Watch for traffic when operating near roadways.
•
Do not touch parts which may be hot from operation.
Allow them to cool before attempting to maintain, adjust,
or service the machine.
•
Lightning can cause severe injury or death. If lightning
is seen or thunder is heard in the area, do not operate
the machine; seek shelter.
•
To minimize fuel and oil leakage, transport the machine
either upright or tipped forward, not tipped to the side.
Before transporting the machine, ensure that the engine
on/off switch is in the stop position.
•
Use properly rated straps or chains to secure the machine
before transporting it.
Maintenance and Storage
•
Stop the engine. Wait for all movement to stop before
adjusting, cleaning, or repairing the machine.
•
Ensure that the engine on/off switch is in the stop
position before storing the machine or performing
maintenance.
•
Clean debris from the drives, muffler, and engine to help
prevent fires. Clean up oil or fuel spillage.
•
Let the engine cool before storing and do not store near a
flame.
•
Do not store fuel near flames or drain fuel from the
machine indoors.
•
Park the machine on level ground. Never allow untrained
personnel to service the machine.
•
Carefully release pressure from components with stored
energy.
•
Remove the spark plug wire before making any repairs.
•
Keep hands and feet away from moving parts. If possible,
do not make adjustments with the engine running.
•
Keep all parts in good working condition and all hardware
tightened. Replace all worn or damaged decals.
•
Keep nuts and bolts tight. Keep equipment in good
condition.
•
Never tamper with safety devices.
•
Keep the machine free of debris buildup. Clean up oil or
fuel spillage. Allow the machine to cool before storing it.
•
Use extra care when handling gasoline and other fuels.
They are flammable and vapors are explosive.
– Use only an approved container.
– Never remove the fuel cap or add fuel when the
engine is running. Allow the engine to cool before
fueling. Do not smoke.
– Never fuel the machine indoors.
– Never store the machine or fuel container inside
where there is an open flame, such as near a water
heater or furnace.
– Never fill a container while it is inside a vehicle, trunk,
pick-up bed, or any surface other than the ground.
– Keep the fuel-container nozzle in contact with the
tank during filling.
•
Stop and inspect the machine if you strike an object. Make
any necessary repairs before starting the engine again.
•
Use only genuine Toro replacement parts to ensure that
original standards are maintained.
•
To minimize fuel and oil leakage, do not lay the machine
onto the right or left side.
•
Store the machine upright.
4