Reset Unit - Sangamo RSTAT5 RF Installation Instructions And Owner's Manual

CUSTOM PROGRAM cont...
Below shows the programming segments of the default program on a Weekday.
6:00am 8:30am
NIGHT MORN DAY
Held over from previous
.
day's setting
Essenti ally, if the thermostat reads the temperature below the chosen temperature it will
send a message for the boiler to fi re and your heati ng to come on.
The above diagram shows how the day is split up into named parts but BOTH the ti mes
and temperatures are changeable. Using the programming instructi ons that follow you
can set the ti me each part starts and the temperature it will set to at that point. As can be
seen the NIGHT setti ng carries over & stays unti l the MORN ti me the following day.
If you don't need a certain program to be there, for example you do not require Noon as
no one is home at that ti me of the day, then you simply set that program for the same
temperature as the one before - as it cannot be deleted. There must be 6 programmed
events each day even if they are set to the same temperature.
CREATING YOUR PROGRAM
Use the grids below to plan out your own custom program before you start.
Mo - Fr Time °C
1: MORN
2: DAY
3: Noon
4: Break
5: EVEN
6: NIGHT
2am 6am 10am
12:00pm 2:00pm 4:30pm 10:30pm
Noon Break EVEN
Sa - Su Time
1: MORN
2: DAY
3: Noon
4: Break
5: EVEN
6: NIGHT
2pm 6pm 10pm
PROGRAMMING
Within programming mode the thermostat will return
to normal operati on if no butt ons are pressed for 30
seconds.
To exit programming mode either wait 30 seconds or
press Set x2 and Ok.
NB: Each day's end ti me is 11:59 in 12hr or 23:59 in 24hr
NIGHT
formats. P6 should never be set for midnight as this will
cause an error in programming.
Each day of the week can be programmed separately,
starti ng with Monday (Mo)
1. Press Set to enter programming mode.
2. Set Mo MORN temperature using ▼▲ and press Ok.
3. Set Mo MORN ti me using ▼▲ and press Ok.
4. Set Mo DAY temperature using ▼▲ and press Ok.
5. Set Mo DAY ti me using ▼▲ and press Ok.
6. Repeat procedure for all 6 set points in the day and
conti nue on to program each day of the week.
At any point Press Set x2 then Ok to return to Run Mode
COPY/PASTE DAY
To speed up the programming sequence you can copy
one day into another, or several other, days.
°C
1. Press Set x2 to enter copy mode.
2. Choose the 'Copy' day using ▲ and press Ok.
3. Choose the 'Paste' day using ▲ and press Ok.
4. Repeat step as required for further 'Paste' days
At any point Press Ok x2 to return to Run Mode

RESET UNIT

To erase all current setti ngs and return to it's factory
default setti ngs & programs.
1. Press and hold Ok and ▼ for 6 seconds.
2. When Reset is displayed push in the Reset butt on.
3. All segments on the display are shown to confi rm
reset has taken place.
Prog is shown at the
top of the display
Copy Prog is shown at
the top of the display