Changing The Batteries; What Is A Programmable Thermostat; User Instructions - Sangamo RSTAT5 RF Installation Instructions And Owner's Manual

Wireless digital programmable thermostat
Table of Contents

Advertisement

CHANGING THE BATTERIES

RECEIVER
This LED indicates if a signal
is being sent to the boiler to
turn on. Blue light indicates the
boiler should be firing.
SERVICE AND WARRANTY
Guarantee: as shown on product identification label.
Any tampering or misuse will invalidate this guarantee.
This
product
must
meet
Waste
Electronic
Electrical Equipment Regulations (WEEE) for suitable
environmental recycling, recovery and/or disposal.
End of life products should be handled in line with local
regulations. Alternatively return end of life product to
Sangamo for correct disposal.
CUSTOMER CARE POLICY
As
part
of
Sangamo's
continuous
improvement
program, the company operates a Customer Care
policy. This means we welcome your comments and
complaints, as it can help us to improve our services
to you, our customer.
Due to our policy of continuous product improvement
and development, the specifications in this guide may
be subject to change without prior notice.
143881 A
When the Battery Low warning sign
appears on the display, replace the
batteries immediately.
Flip to open the battery compartment
on the plastic housing.
Upper compartment
2x 1.5v Alkaline AAA for transmitter
Lower compartment
2x 1.5v Alkaline AAA for back light and
transmitter
DO NOT USE RECHARGEABLE BATTERIES
If LED is permanently lit no RF
signal is being found. Heating will
turn off after 10 minutes if no RF
transmission resumes. After the
RF signal is recognised the heating
schedule will continue.
Manual button. If RF signal fails, for
example if the batteries in the thermostat
are flat, this button can turn the heating on
and off.
and
WEE/JH0069TY
Sangamo Limited
Industrial Estate, Port Glasgow,
Renfrewshire, PA14 5XG
Tel 01475 745131
Fax: 01475 600370
Email: enquiries@sangamo.co.uk
Web: www.sangamo.co.uk
Choice RSTAT5 RF
Wireless Digital Programmable Thermostat

User Instructions

WHAT IS A PROGRAMMABLE THERMOSTAT?

A programmable thermostat differs from a programmer that you may be used to.
With this thermostat you do not set on and off times. Instead you are setting your
desired temperature at varying points throughout the day. This means your home
will always be comfortably warm when needed but you will not be wasting energy
(and money) heating your home when it's not required.
If your thermostat is set to 21°C, for example, your boiler will run until the
thermostat reads over that temperature and then tell the boiler to turn off,
meaning you won't be calling for heat when your home is already at your desired
temperature.
When you set a temperature you are saying you don't want the heating to come on
unless the room temperature is lower than the set temperature.
INTRODUCTION
The Choice RSTAT5 RF comprises of a portable battery powered thermostat
(transmitter) and a separate wall mounted mains relay box (receiver). The
transmitter should be located in the main living area and the receiver is mounted
close to the boiler.
This programmable room thermostat has been designed to bring you comfort and
energy economy. It allows you to program and regulate your heating system using
up to 6 programmable events per day.
To ensure its correct operation the thermostat should be mounted or situated
approximately 1.3m above the floor and away from direct sunlight, heat sources and
drafts.

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RSTAT5 RF and is the answer not in the manual?

Questions and answers

Table of Contents