Related Manuals for UEi CD100A
Summary of Contents for UEi CD100A
- Page 1 CD100A Combustible Gas Leak Detector INSTRUCTION MANUAL ENGLISH 1-800-547-5740 www.ueitest.com • email: info@ueitest.com...
-
Page 2: Table Of Contents
TABLE OF CONTENT Safety Tips Introduction International Symbol Functions Features Operating Instructions Specifications Sensor Filter and Sensor Replacement Battery Replacement Replacement Parts Optional Accessories Electromagnetic Compatibility Warranty Disposal Cleaning Storage SAFETY TIPS One year limited warranty Using this detector, read all safety information carefully. “WARNING”... -
Page 3: Introduction
INTRODUCTION The CD100A Combustible Gas Leak Detector is capable of sensing many combustible, non-combustible and toxic gases that include but are not limited to the following: Acetone Industrial Solvents Alcohol Jet Fuel Ammonia Lacquer Thinners Benzene Methane Butane Naphtha Ethylene Oxide... -
Page 4: International Symbol
INTERNATIONAL SYMBOLS Dangerous Voltage Ground AC Alternating Current Warning or Caution Double Insulation DC Direct Current (Protection Class ll) Either AC or DC Fuse Not Applicable to Battery Identified Model FUNCTIONS • Senses leading combustible, non-combustible, and toxic gases • Minimum detection: 50 ppm methane FEATURES •... -
Page 5: Operating Instructions
OPERATING INSTRUCTIONS Turn the instrument on by rotating the thumbwheel downward in a non-contaminated environment (fresh air). The green power LED will be illuminated when the unit is turned on. If the battery level is low, the red LED will be steady and the tic will not be adjustable. -
Page 6: Specifications
SPECIFICATIONS Power supply: 1 x 9V battery Sensor: Solid state semi conductor Sensitivity: < 50 ppm methane Indicators: Audible: Adjustable tic rate Visual: Flashing LED Warm-up: 10 seconds Response Time: Instantaneous Duty Cycle: Continuous Battery Life: 5 hrs. typical use Dimensions: 8”... -
Page 7: Battery Replacement
(April 1998). This advice is only given to satisfy the requirements of the directive. This product has been tested for compliance with the following generic standards, and it is certified to be compliant. EN 50081-1 • EN 50082-1 Specifications EC/EMC/K1/CD100A details the specific test configuration, performance and conditions of use. -
Page 8: Warranty
WARRANTY The CD100A is warranted to be free from defects in materials and workmanship for a period of one year from the date of purchase. If within the warranty period your instrument should become inoperative from such defects, the unit will be repaired or replaced at UEi’s option.
Need help?
Do you have a question about the CD100A and is the answer not in the manual?
Questions and answers