Salus RT310TX Quick Manual

RT310, RT310TX, RT310RF
Quick Guide
Introduction
RT310 / RT310TX / RT310RF is a digital room thermosat used to control room temperature. Device
launching heating system by shorting terminal blocks, simultaneously informing the action and
showing this information on the LCD display. Before use please read this manual carefully. Use only
AA 1.5 V alkaline batteries in the thermostat. Place the batteries into the battery slot located under the
cover. Do not use rechargeable batteries.
Product compliance
This product complies with the essential requirements and other relevant provisions of the following EU Directives:
EMC 2014/30/EU, LVD 2014/35/EU, RED 2014/53/EU and RoHS 2011/65/EU. Full text of the EU Declaration of
Conformity is available on www.saluslegal.com
868.0-868.6MHz; <13dBm
Safety Information
Use in accordance to national and EU regulations. Use the device as intended, keeping it in dry condition.
Product for indoor use only. Installation must be carried out by a qualified person in accordance to
national and EU regulations.
Technical specification
RT310
Thermostat supply 2 x AA alkaline batteries
Receiver supply -
Thermostat rating max 3 (1) A
Receiver rating max -
Voltage free
Outputs
NO / COM /NC terminals
Temperature range 5 - 35°C
Button functions
RT310 / RT310TX Thermostat
1
2
1. Turn on the LCD backlight
2. Turn On/Off the Frost Mode
3. Increase button
4. Decrease button
LCD Icon description
1
2
3
4
RT310 Terminals description
Terminal
1 - COM
2 - NC
3 - NO
RT310TX
RXRT510 Receiver terminals description
2 x AA alkaline batteries
Terminal
230 V AC
NO
-
COM
16 (5) A
L, N
Voltage free
NO / COM terminals
5 - 35°C
RXRT510 Receiver
3
4
5
7
5. When in Manual Mode,
ON will turn the boiler on.
6. When in Manual Mode,
OFF will turn the boiler off.
7. Receiver operates in automatic mode
according to the thermostat
8. Receiver output is controlled
by the On/Off slide switch.
1. Heating Mode ON
5 2. Frost Protection Mode ON
3. RF signal indicator (only in RT310RF)
6
4. Low battery status
5. Temperature unit
6. Room / setpoint temperature
Description
Common Terminal
Switched Live OFF
Switched Live ON
Description
N
L
Switch Terminal COM
Common Switch Terminal
NO
NO COM L N
Supply (230 V AC)
DIP Switch Settings
The DIP Switches can be found on the rear of your thermostat.
Control feature
Operation
N
L
COM
6
NO
8
RT310 Wiring diagram
RT310RF Wiring diagram
Note: If you are using the RT310RF pack, the pairing between the thermostat and the receiver
is already done.
N L
TPI Span
When TPI is selected on DIP When Span is selected
N
L
switch № 2, the DIP switch № on DIP switch № 2,
COM
1 is functional. You can choose the DIP switch № 1 is
the Cycles Per Hour between not functional. The
a lower comfort level (6CPH) temperature accuracy of
NO
and a higher comfort level your thermostat is set to
N L
(9CPH). ± 0.25 °C.
N L
AC 230 V
L
AC 230 V
L
MAX
3 (1) A
MAX
3 (1) A
M
OR
M
OR
N
N
N
L
COM
NO
N L
AC 230 V
L
N
L
COM
MAX
3 (1) A
NO
MAX OR
16 (5) A
N L
M
L, N Na
OR
N