Orbit SunMate 62062 Manual

dual outlet dIGItal tImer
PROGRAMMING FOR THE DIGITAL
■
PORT OF THE TIMER
THE MANUAL PORT CANNOT bE
■
PROGRAMMED DIGITALLy
INSTALLING THE bATTERIES
Remove the tray on the back of the timer by
■
sliding it out.
Insert two AA (1.5V) alkaline batteries
■
(not included) and replace the tray.
Replace batteries when low battery icon appears.
■
INSTALLATION
Attach timer to an outdoor hose faucet and turn
■
on after programming.
PROGRAMMING THE TIMER
Rotate the dial to positions indicated for setup.
■
SET CLOCK
Press the + button to advance clock time
■
(hold button for quick advance).
Press the – button to reverse clock time
■
(hold button for quick reverse).
START TIME
Press the + button to advance start time
■
(hold button for quick advance).
Press the – button to reverse start time
■
(hold button for quick reverse).
HOW LONG
Set watering duration from 1 to 240 minutes using
the + and – buttons.
HOW OFTEN
Set watering frequency as every 6 hrs, 12 hrs, or
from 1 to 7 days using the + and – buttons. 1 is
every day, 2 is every other day etc. up to 7 days.
AUTO
Timer waters according to programmed time,
duration, and frequency.
RAIN DELAy
When in AUTO, press + button for 24 hrs,
■
48 hrs, or 72 hrs.
Screen will flash between clock and hours
■
remaining before programmed cycle resumes.
To remove rain delay, turn dial to OFF and then
■
back to AUTO.
MANUAL/HAND WATERING
To water without interrupting the set cycle, press
[MANUAL] button and then use + and – buttons to
set from 1 to 240 minutes.
To remove manual watering (turn off),
■
turn dial to OFF.
To resume programmed cycle turn the
■
dial back to AUTO.
MANUAL PORT
The manual port of the timer gives access to the
hose faucet without interrupting the programmed
cycle of the digital port.
Open the valve in the port by turning the lever
■
counterclockwise to the open position.
Close the valve by turning the lever to the
■
closed position.
TROUbLESHOOTING
Water does not come on at desired time.
Check if:
Clock is set to correct time including AM and PM
■
Start time is set to desired time including
■
AM and PM
Rain Delay is on
■
Timer does not water.
Check if:
Faucet is on
■
Timer is set to AUTO
■
Hose faucet is on
■
Batteries are low
■
Clock is set to correct time including AM and PM
■
Rain Delay is on
■
Water won't turn off.
Check if:
Watering duration is set to desired time
■
Start times begin after previous watering cycle
■
has run through all stations and set durations
For bypass/manual port: close valve
■
When expecting freezing temperatures,
timers should be removed from the hose
bib to avoid potential freeze damage.
Working Water Pressure
Minimum: 25 psi Maximum: 100 psi
Working Temperature
Maximum: Do not exceed 120 degrees F
Minimum: Keep from freezing
Warnings
For outdoor use with cold water only.
Orbit Irrigation Products, Inc.
®
North Salt Lake, UT 84054
1-800-488-6156
www.orbitonline.com
© 2011 Orbit Irrigation Products, Inc.
All rights reserved. All trade names are
registered trademarks of respective
manufacturers listed. PN 62062-24 rE