Table of Contents
Advertisement
Purchase at Allstrap (866) 779-2673
1.4.2 Troubleshooting
Ensure before each tool repair that the battery is charged and
SYMPTOM
Tool doesn't work at all
Tool doesn't tension
Tensioning wheel turns
back immediately after the
tensioning cycle
the tool's specific strap is used
CAUSE
Battery is empty or defective
Contact problems caused by a broken
battery housing
Contact problems caused by a
damaged insertation part N51.2194 or
damaged motor housings P32.8103
and P32.8105/96
Contact problem of the internal wires
Defective circuit board
Tensioning wheel is dirty or worn
P32.8128 is not meshing with
P32.8130 because spring N2.5296 is
defective or parts are dirty
Faulty tensioning wheel or tensioning
wheel is assembled reversed
Grippers are dirty, worn or wrongly
assembled
Gearing parts from the tensioning gear
are defective
Defective circuit board
Defective gear bearings
Needle free wheeling N3.4509 in gear
wheel P32.8139 or N3.4520 in conical
gear wheel P32.8138 assembled
reversed or defective
Defective needle free wheeling
N3.4509 in P32.8134
REMEDY
Charge or replace battery
Replace battery
Replace insertation part or
motor housing
Check contacts and fix them if
required or change defective parts
Replace circuit board
Clean tensioning wheel or replace it,
don't use any hard objects for this
(see operation manual P328)
Replace spring N2.5296,
clean dirty parts
Correct assembling
(see operation manual P328)
Replace grippers, clean them or
assemble correct,
don't use any hard objects for this
(see operation manual P328)
Check tensioning gear and replace
defective parts
Replace circuit board
Replace bearings
Assemble the needle free wheeling
correct or replace it
Check parts and replace if necessary
1-9
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the P328 M and is the answer not in the manual?
Questions and answers
We are at -8 deg and the tool doen't want to operate what can I do
The Fromm P328 M tool is not operating at -8 degrees because its recommended ambient working temperature range is between -10°C and 45°C (14°F to 113°F), with optimal performance between 15°C and 20°C (59°F to 68°F). Although -8 degrees is technically within the operational range, the tool may not perform properly as it is near the lower limit of the specified range, where performance could be affected.
This answer is automatically generated
The FROMM P328 will not operate more than once, after operating there is a red light that comes on, then after resetting (removing and replacing the battery) it works again but the same thing happens
A red light on the Fromm P328 M after one operation could indicate a battery issue, such as an empty or defective battery. It may also point to contact problems, a defective circuit board, or internal wiring issues. Check the battery charge, ensure proper contact, and inspect for damaged or defective parts.
This answer is automatically generated