Battery Charging; Changing Tools - Challenge Xtreme KD703-T2180LI Original Instructions Manual

ASSEMBLY
Battery pack's assembly and
disassembly
• Insert battery pack into the bottom of the
handle ( until click )
• Remove the battery pack by pressing the
unlock button 8 on the battery pack at the
same time and by pulling the battery pack out
Pic.B
9
.
8
a. Cordless drill
8. Battery unlocking button
9. Battery pack

Battery Charging

• Put the battery pack in the charger stand.
Make sure it is placed correctly ( + and - )
• Plug in the socket-outlet( 100-240V~ )
• When the indicator light starts burning this
means the battery pack is now being charged.
Normally it will take 1-1.5hour to fully charge
the battery.
When the red indicator light turned off and
green indictor light turned on, this means the
battery is fully charged.
• Unplug the plug after charging

Changing Tools

• Before any work on the machine
(e.g., maintenance, tool change,
etc.) as well as during transport
10
ORIGINAL INSTRUCTIONS
a
HELPLINE NO 08454 505299
and storage, set the rotational
direction switch to the centre
position. Unintentional actuation of the
On/Off switch 7 can lead to injuries.
• To insert a drill bit / screwdriver bit, hold the
back section of the chuck and rotate the front
section of the chuck
• Insert the drill bit / screwdriver bit into the
chuck ( as far as possible )
• For screwdriver bits use an adaptor
• Select the correct screwdriver bit to avoid
damaging the screw
• Firmly tighten the chuck by hand and check
if the drill bit / screwdriver bit is seated firmly
OPERATION
INSTRUCTIONS
Starting Operation
Inserting the Battery
Use only original lithium ion
batteries with the voltage listed on
the nameplate of your power tool.
Using other batteries can lead to injuries and
pose a fire hazard.
1) Set the rotational direction switch 6 to the
centre position in order to avoid
unintentional starting.
2) Insert the charged battery 9 into the handle
as Pic.B shown so that it can be felt to
engage and faces flush against the handle.
1. Switching on:
To start the appliance squeeze on the On/Off
switch 7 and then keep it pressed down.
2. Note:
The power light 5 lights up when the On/Off
switch 7 is slightly depressed, and enables
illumination of the screwing location in
unfavorable light conditions.