Hand Held Programmer - Fike 10-071 Installation Manual

3.11.2 HAND HELD PROGRAMMER, P/N 10-2648 (NON-LISTED)
The Hand Held Programmer (See Exhibit 3-49) provides the user the
ability to address the Cheetah Xi 50 addressable devices.
Hand Held Programmer contains the same operating code as the
Cheetah Xi 50 and can be used as a training device and/or
troubleshooting tool.
Refer to Fike document 06-390 for more information.
3.11.3 C-LINX SOFTWARE, P/N 06-327
The C-Linx Software provides a computer interface to the Cheetah Xi
50 controller. It provides the designer the tools to design a system in
their office and then load the configuration at the project site. It also
provides the ability to retrieve, save and print the configuration and
history of events from the control panel as well as perform several
diagnostic functions.
Refer to Fike document 06-448 for more information.
3.11.4 INTERFACE CABLE, P/N 10-2629
The 10-2629 interface cable (See Exhibit 3-50) consists of a USB 2.0
A/B Male-to-Male assembly. It should be used when programming
using the C-Linx Software to the 50 point panel or Handheld
Programmer.

Note: Requires drivers for proper operation.
downloaded from Fike Customer Portal.
UL S2203
FM
The
Drivers can be
Cheetah Xi 50 Installation Manual
P/N: 06-369
3.0 SYSTEM COMPONENTS
Exhibit 3-49: Hand Held
Programmer
Exhibit 3-50:
USB Communication Cable
Rev 6, 09/2015
3-23