Table of Contents
Advertisement
AN2 Series
Installing Projector
1.
Attach projector interface (T) to projector using four
M4 x 12mm Phillips cap head screws (V). (See Figure 10)
Figure 10
NOTE:
Make sure projector mount is in UNLOCKED position
and remove key from projector mount.(See Figure 11)
2.
Lift projector with attached interface (T) and slide buttons on
interface into slots on boom projector mount (S). (See
Figure 11)
3.
Slide latch to LOCKED position to lock projector in place.
(See Figure 11)
4.
Add and route cables following instructions included with
the projector.
NOTE:
Do NOT place extra cable length behind the sensor
bracket.
10
1
(V) x 4
(T)
LOCKED
Slot
Buttons
Figure 11
5.
Place a level on top of the boom arm mount and level the
mount after the projector is installed. (See Figure 12)
5A. Tighten nut to increase boom arm angle.
5B. Loosen nut to decrease boom arm angle.
6.
Place a level on top of interface (T) and level. (See Figure 12)
CAUTION:
While leveling mount:
•
Ensure nut is fully engaged onto bolt, and AT LEAST
ONE thread appears through nut.
•
DO NOT over tighten nut! Over tightening WILL
damage wall behind mount.
5A
5B
Figure 12
Installation Instructions
Latch
Slot
(S)
UNLOCKED
3
2
(T)
5A
5B
Advertisement
Table of Contents
