Vivo DESK-V101E Assembly Instructions

ELECTRIC
Height Adjustable Desk Frame
ASSEMBLY INSTRUCTIONS
WARNING: FAILURE TO COMPLY WITH OR OBSERVE ALL
ASSEMBLY, SAFETY AND OPERATION INSTRUCTIONS AND
WARNINGS REGARDING THE USE OF THIS PRODUCT MAY
WARNING RESULT IN SERIOUS BODILY INJURY.
Important information
Read the entire instruction manual before you start
installation and assembly.
This product is not intended for use by young children without supervision.
This product contains small items that could be a choking hazard if
swallowed. Keep these items away from children.
This product is intended for indoor use only. Using this product outdoors
could lead to product failure and personal injury.
IMPORTANT: Ensure that you have received all parts according to the
component checklist prior to installation. If any parts are missing or
faulty, telephone your local distributor for a replacement.
QUICK TIP: DO NOT over tighten screws during installation.
CAUTION:
·This product can be used under the standard technical parameters only.
·Please place the product away from corrosive gas, water and dusty
environment.
·Please do not disassemble the pre-assembled components, as this will
void the warranty.
Tools
Needed
Component Checklist
A
(x1)
telescopic frame
B
(x2)
upper support
C
(x2)
base support
E
(x1)
lifting column
D F G
(x1) (x1) (x1)
lifting column control panel power cord
S-A (x24) S-B (x2) S-C (x8)
S-D (x1) S-E (x3) S-F (x8)
Allen key cable clip rubber pad
1
Adjusting the Frame
·Loosen the screws using the Allen key.
·Remove the hexagon rod.
A
hexagon rod
·Loosen the cross-head screws using
an appropriate screwdriver.
·Loosen the hexagon socket button
head screws using the Allen key.
cross-head screw
hexagon socket button
head screw
·Adjust the extension frame length to
suit the desktop and tighten all screws
to secure the extension frame in place.
extension frame
2
Assembling the Lifting Columns
·Insert the previously removed hexagon rod through the hole in the lifting column.
·Attach the lifting columns to the frame using the proper screws
and tighten all screws with the Allen key.
S-A