Insignia NS-LED16RGB18 Quick Setup Manual

QUICK SETUP GUIDE
16 ft. Multi-Color
LED Tape Light
NS-LED16RGB18 / NS-LED16RGB18-C
WARNING: Unroll before use. Never plug in the LED lights
when rolled up, as this can result in product damage or a fire.
PACKAGE CONTENTS
• LED tape light • Double-sided tape
• Remote control • RF controller box
• Screws (2) • Quick Setup Guide
FEATURES
• Premium LEDs produce 15 selectable colors and white light
• 16 ft. LED tape light can be cut to length
• Remote control works anywhere in the room—no need to
point at the light
• Multi-step dimmer adjusts to the brightness level you want
• Four modes of flashing: Flash, Strobe, Fade, and Smooth
• Self-adhesive backing adheres to TVs, cabinets, or other
surfaces for quick, custom lighting
• Powered by AC wall power for constant use
Before using your new product, please read these instructions to prevent any damage.
Tape light
AC adapter
RF controller box
Waterproof connector Waterproof connector
Cut line
Remote control
Remote control
Adjusts brightness and speed
Turns on and off
Selects a color
Cycles through red, green, and blue
Changes the various transition modes
USING YOUR TAPE LIGHT
Shortening your tape light
• Use a pair of scissors to cut on a cut line. Cut lines are about
3.9 in. (9.9 cm) apart.
Warning: Do not cut the silver solder markings. Only cut in the
center of the copper-colored pads, as shown.
Cut line
Cut line
Attaching your lights
1 Peel the adhesive backing off the lights, then adhere the
lights where you want them.
2 Optional: Attach the double-sided tape to the back of the
RF controller box, then adhere it where you want it.
OR
Attach the RF controller box to a surface using the included
screws. There are two holes on the controller box to allow
for a firm attachment.
Notes:
• Make sure that the tape light is unrolled, otherwise it can
damage the tape light or cause a fire.
• Every surface is different, and additional adhesive may be used
if the LED tape detaches from the surface. Small pieces of clear
tape can be used.
Connecting to power
1 Push both ends of the waterproof connectors together,
making sure that the arrows line up.
Cut line
2 Turn the cap until it is secure.
3 Plug the AC adapter into a power outlet.
4 Remove the plastic battery-saver tab from the remote
control.
Arrows
Cap
AC adapter