Operating The Base Station On The Pabx/Router; Resetting The Handset - Gigaset A150 Manual

Resetting the handset

You can reset individual settings and changes that you have made. Entries in the directory, the calls list and the handset's
registration to the base station will be retained.
¤ u
¤
MENU Settings
a
Cancel the reset with
Resetting the base station
When restoring factory settings the No Radiation mode is deactivated, individual settings are reset and all lists are
deleted.
The date and time are retained. The answer machine (A150A/A250A only) is ready for use approx. 15 seconds after the
base has been reset.
Resetting the base via the menu
Handsets are still registered, the system PIN is not reset.
¤ u
¤
MENU Settings
Resetting the base using the key on the base
All handsets are de-registered and the system PIN is reset to the original code 0000.
Carry out the following steps: Remove the mains cable from the base. Hold down the registration/paging key on the
¢ ¢
base ( S. 1)( S. 2) and reconnect the power cable to the base at the same time. Hold the key down for at least
5 seconds.

Operating the base station on the PABX/router

Operating on the router
When operating the Gigaset on an analogue port of a router you can reduce problems with echoes by activating the
¢
Echo mode ( S. 17). If you have no problems with echoes, this function should be deactivated.
Operating on the PABX
The following settings are only necessary when your PABX requires them; see the user guide for your PABX.
When entering the digits, enter them slowly one after the other.
Changing the dialling mode
P#Q5#1N
¤
MENU
¤
pulsing (DP) enter number
Setting recall
P#Q5#1Q
¤
MENU
3 = 400 ms; 4 = 250 ms; 5 = 300 ms; 6 = 600 ms; 7 = 800 ms
Changing pause after line seizure
You can set the length of the pause inserted between pressing the talk key
P#Q5#1L
¤
MENU
¤ ¤
.
enter number OK
Changing the pause after the recall key
P#Q5#12
¤
MENU
¤ ¤
ms enter number OK
¤ u
¤
OK Handset OK
.
¤ u ¤ u
¤
OK Base OK
¤
The number for the set dialling mode flashes: 0 = touch tone dialling (DTMF); 1 = dial
¤
.
OK
¤
The number for the current recall flashes: 0 = 80 ms; 1 = 100 ms; 2 = 120 ms;
¤
The number for the current pause length flashes: 1 = 1 sec.; 2 = 3 sec.; 3 = 7 sec.
¤
The number for the current pause length flashes: 1 = 800 ms; 2 = 1600 ms; 3 = 3200
.
12
¤ u
¤
Reset Handset
¤ ¤
Base Reset OK Reset?
¤
enter number
¤ ¤
OK Reset? OK
¤
OK
¤
.
OK
b
and sending the phone number.