Advertisement
Table of Contents
Deacon Ottoman bed
Assembly Instructions
Minimum No.of people
recommended to assemble
this product:
Approx assembly time:
Before you
Start, here
are some
helpful
advices.
Revision number 1/1
2
1
hour
1. We suggest you spend a short time reading through this leaflet and then follow
the simple step by step instructions.
2. If you follow the instructions carefully the end result should be worth the effort.
3. Do not discard any of the packaging until you have checked that you
have all the parts and the pack of fittings.
4. Assemble this product on a carpet.
5. To ensure an easier assembly, we strongly advise that all fittings are only
finger tightened during initial assembly. Only upon completion of the.
Assembly should all fixing points be fully tightened.
6. We recommend a periodic check on all fixing points to make sure they remain
fully tightened.
7. Keep glue and fittings out of children s reach.
In the unlikely event that this product has missing or damaged parts, please call
03442 920000 to obtain spares
Advertisement
Table of Contents
Related Manuals for DREAMS Deacon Ottoman
Summary of Contents for DREAMS Deacon Ottoman
- Page 1 Deacon Ottoman bed Assembly Instructions Minimum No.of people recommended to assemble this product: hour Approx assembly time: Before you 1. We suggest you spend a short time reading through this leaflet and then follow Start, here the simple step by step instructions.
- Page 2 PARTS Fittings NO. PART LIST (1) HEADBOARD (2) FOOTBOARD (3) SIDE RAILS ( R&L) (4) SUPPORT BRACKETS (5) BOTTOM BOARD (6 ) SLATTED BED FRAME ( R&L) (7 ) JOINING BRACKETS (8) MATTRESS HOLDER (9) FABRIC PULL HANDLE Revision number 1/1...
- Page 3 ASSEMBLY (1). Loosen the pre-assembled bolts STEP 1 on the headboard and footboard with the Allen Key (J) (K) . (2). Attach the side rails to the headboard and footboard. Note: Leave 10 mm protruding as in the diagram Revision number 1/1...
- Page 4 ASSEMBLY MAKE CERTAIN THE BED IS STEP 2 SQUARED UP .AS SHOWN ON THE RIGHT. Once all four comers are located. make sure the bed is still square as in the sketch.then tighten all the bolts 100% using Allen key (J)(K) Revision number 1/1...
- Page 5 ASSEMBLY (1). Attach the support brackets STEP 3 to the headboard and footboard by using bolts (A) , washer (H) and allen key (K). Revision number 1/1...
- Page 6 ASSEMBLY (1). Fix the bottom boards STEP 4 Revision number 1/1...
- Page 7 ASSEMBLY 1) Join the two halves together using STEP 5 the bolt (B) through the holes and tighten with the M8 nut. 2) Slot the bolts (C) through the holes and tighten with the M6 JCN nuts. Complete at head and foot end of frame.
- Page 8 ASSEMBLY 1) While one person holds the slatted STEP 6 frame up, the second person must fit the gas strut to the hinge. 2) One end of the strut will already b e attached to the hinge. At the other end, take the nut off the bolt and attach the other end of the strut.
Need help?
Do you have a question about the Deacon Ottoman and is the answer not in the manual?
Questions and answers