Table of Contents
Advertisement
36
Set Lengths for Interleaved 2 of 5
The length of a code refers to the number of characters (i.e., human readable characters), including check digit(s)
the code contains. Lengths for I 2 of 5 may be set for any length, one or two discrete lengths, or lengths within a
specific range.
Note: When setting lengths, single digit numbers must always be preceded by a leading zero.
One Discrete Length - Select this option to decode only those codes containing a selected length. For example,
select I 2
of 5 One Discrete Length, then scan 1, 4, to decode only I 2 of 5 symbols containing 14 characters.
Numeric bar codes begin on page 51. To change the selection or cancel an incorrect entry, scan the Cancel bar
code on page 51.
Two Discrete Lengths - Select this option to decode only those codes containing two selected lengths. For example,
select I 2 of 5 Two Discrete Lengths, then scan 0, 6, 1, 4, to decode only I 2 of 5 symbols containing 6 or 14
characters. Numeric bar codes begin on page 51. To change the selection or cancel an incorrect entry, scan the
Cancel bar code on page 51.
Length Within Range - Select this option to decode only codes within a specified range. For example, to decode I
2 of 5 symbols containing between 4 and 12 characters, first scan I 2 of 5 Length Within Range, then scan 0, 4, 1
and 2 (single digit numbers must always be preceded by a leading zero). Numeric bar codes begin on page 51. To
change the selection or cancel an incorrect entry, scan the Cancel bar code on page 51.
Any Length - Scan this option to decode I 2 of 5 symbols containing any number of characters.
Note: Selecting this option may lead to misdecodes for I 2 of 5 codes.
Revision: 2.0 , technical changes excepted
I 2 of 5 - One Discrete Length
I 2 of 5 - Two Discrete Lengths
I 2 of 5 - Length Within Range
I 2 of 5 - Any Length
Advanced Scanner Configuration Guide
Advertisement
Table of Contents
