Set Lengths For Code 93 - Philips SpeechMike Configuration Manual

Hide thumbs Also See for SpeechMike:

Table of Contents

Advanced Scanner Configuration Guide

Set Lengths for Code 93

The length of a code refers to the number of characters (i.e., human readable characters), including check digit(s)

the code contains. Lengths for Code 93 may be set for any length, one or two discrete lengths, or lengths within a

specific range.

One Discrete Length - Select this option to decode only those codes containing a selected length. For example,

select Code 93 One Discrete Length, then scan 1, 4, to limit the decoding to only Code 93 symbols containing 14

characters. Numeric bar

codes begin on page 51. To change the selection or cancel an incorrect entry, scan the

Cancel bar code on page 51.

Code 93 - One Discrete Length

Two Discrete Lengths - Select this option to decode only those codes containing two selected lengths. For

example, select Code 93 Two Discrete Lengths, then scan 0, 2, 1, 4, to limit the decoding to only Code 93

symbols containing 2 or 14

characters. Numeric bar codes begin on page 51. To change the selection or cancel an

incorrect entry, scan the Cancel bar code on page 51.

Code 93 - Two Discrete Lengths

Length Within Range - This option sets the unit to decode a code type within a specified range. For example, to

decode Code 93 symbols containing between 4 and 12 characters, first scan Code 93 Length Within Range, then

scan 0, 4, 1 and 2 (single digit numbers must always be preceded by a leading zero). Numeric bar codes begin on

page 51. To change the selection or cancel an incorrect entry, scan the Cancel bar code on page 51.

Code 93 - Length Within Range

Any Length - Scan this option to decode Code 93 symbols containing any number of characters.

Code 93 - Any Length

Revision: 2.0 , technical changes excepted

Table of Contents