Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for General MM1E
Summary of Contents for General MM1E
- Page 1 PIN-TYPE LED BAR GRAPH MOISTURE METER USER’S MANUAL MM1E 99 Washington Street Melrose, MA 02176 Phone 781-665-1400 Toll Free 1-800-517-8431 Visit us at www.TestEquipmentDepot.com Please read this manual carefully and thoroughly before using this product.
-
Page 2: Table Of Contents
TABLE OF CONTENTS Introduction ......3 – 4 Key Features ......4 What’s in the Blister Pack . -
Page 3: Introduction
The wetter a material, the higher its conductivity. The two replaceable steel pins at the top of the MM1E serve as the electrodes of a conductance meter optimized for measuring moisture content. -
Page 4: Key Features
• Protective cap doubles as calibration checker • Full Battery and Low Battery indications WHAT’S IN THE BLISTER PACK The MM1E comes in a plastic blister pack along with a “9V” battery, a protective cover for the test pins and this user’s manual. -
Page 5: Product Overview
PRODUCT OVERVIEW The figure below shows all of the controls and indicators on the front and the back of the MM1E, as well as the location of the battery compartment on the back. Calibration check holes Protective Cover Test pins... -
Page 6: Setup Instructions
OPERATING INSTRUCTIONS To power on the MM1E, slide the Power/Scale switch on the back of the meter to the HIGH position. Moving the switch should cause some or all of the LEDs on the front panel to illuminate in sequence from bottom to top. - Page 7 To check the calibration of the MM1E, power on the meter by sliding the Power/Scale switch to the HIGH position. Remove the protective cap from the top of the meter, taking care not to stab yourself with the two sharp pins beneath the cap.
-
Page 8: Specifications
6. The MM1E has no auto power off function. To avoid discharging the battery, manually power off the meter after each measurement session by sliding the Power/Scale switch on the back to the OFF position. -
Page 9: Replacement Parts
Acceptance of the exclusive repair and replacement remedies described herein is a condition of the contract for purchase of this product. In no event shall General be liable for any incidental, special, consequential or punitive damages, attorneys’ fees, expenses, losses alleged to be a... -
Page 10: Return For Repair Policy
Customer Service Department. If the product is determined to require repair under the General Tools & Instruments Warranty Policy, you will be issued a Return Goods Authorization. The unit will be sent via prepaid freight to the attention of our Service... - Page 11 99 Washington Street Melrose, MA 02176 Phone 781-665-1400 Toll Free 1-800-517-8431 Visit us at www.TestEquipmentDepot.com Specifications subject to change without notice ©2016 GENERAL TOOLS & INSTRUMENTS NOTICE - WE ARE NOT RESPONSIBLE FOR TYPOGRAPHICAL ERRORS. MAN#MM1E 11/29/16...
Need help?
Do you have a question about the MM1E and is the answer not in the manual?
Questions and answers
How do I reset and calibrate my MM1E?