Web Remote Control - Provision ISR Ossia NVR5 Series User Manual

Remote Surveillance

PPPoE Access
① Click StartSettingsNetworkTCP/IPv4. Check "Enable" in the "PPPoE settings" and
input the username and password you get from your ISP. Click "Apply" to save the settings.
② Click StartSettingsNetworkNetwork Status to view the IP address of the NVR.
③ Open IE browser on a computer, input the IP address of the NVR in the web browser
address bar and press enter. Input the username and password of the NVR and click "Login" to
go to the device's web interface.

Router Access
① Click StartSettingsNetworkTCP/IPv4. Set the IP address, subnet mask, gateway,
preferred DNS and alternate DNS of the NVR.
② Set the HTTP port (it is advised to modify the HTTP port since the default HTTP port 80
might be occupied) and enable UPnP function in both the NVR and the router. If the UPnP
function is not available in the router, you need to forward the LAN IP address, HTTP port and
server port of the NVR to the router. Port mapping settings may be different in different routers,
so please refer to the user manual of your router for details.
③ Get the WAN IP address of the NVR from the router. Open internet browser on a computer
and input the WAN IP address plus HTTP port like http://116.30.18.215:100 in the browser's
address bar. Press enter to go to the login interface. Input the username and password of the
NVR in the interface and click "Login".
Note: If the WAN IP address is dynamic, it is necessary for you to use the domain name to access the
NVR. Click Start
details). By using DDNS function you can use the domain name plus HTTP port to gain remote access
to the NVR remotely

12.4 Web Remote Control

The supported browsers of the remote surveillance are IE8/9/10/11, Firefox, Opera Windows
OS and Safari in MAC OS.
When you access the NVR through web browser for the first time, you will need to download
and install the web-client components. The buttons and icons on the top right corner of the
remote interface are introduced as follows.
admin: the logged user name.
Logout: click to log out of the system and return to the login interface.
Modify Password: click to change the password of the current user. Input the current password
and set a new password in the popup window. Click "OK" button to save the new password.
Local Settings: click to change the local settings. Set the snapshot number, path and record
path as shown below. Click "Apply" button to save the settings.
  
Settings Network DDNS to set DDNS (see 11.1.3 DDNS Configuration for
87
User Manual