Thermo Scientific TriPlus RSH User Manual page 152

3
Setup Menu Item
Setup Menu Item Modules
Signals Option Pull-up Menu
126 TriPlus RSH User Guide
Table 56. Output Signal Parameters (Sheet 2 of 2)
Item
Destination Aux
Pulse Duration
Selecting the pull-up menu Options opens up the following tasks. See
Table 57. Option Pull-up Menu for Signals
Item
New Signal
Copy Input Signal
Copy Output Signal
Delete Input Signal
Delete Output Signal
Set Signal
Reset to Default
Description
Used for cases where one command is sent to two different
GC which must be started at the same time.
Selects the time how long the signal is sent.
Description
Creates a new Input or Output Signal. A dialog window
opens allowing you to assign a unique name to the new
signal. When finished, press New and the entire class with
the corresponding parameters is copied over.
Select the required contact, such as a TTL-In or a SW Out
using the parameter Source.
The signal name does not require to be in a consecutive
order for example, Input Signal 2, it can also be a
specifically-named signal such as Inject or Start. Some cycles
require a specifically-named signal. Check the cycle
description for specific names.
An Input Signal can be copied with this task. The task
functions in a similar manner as described above with New
Signal.
Copies an Output Signal. The task functions in a similar
manner as described above with New Signal.
Deletes an Input Signal which is no longer required for the
system configuration in combination with an external
device.
Deletes an Output Signal which is no longer required for the
system configuration in combination with an external
device.
Activates the selected signal for the time set with the
parameter Duration. Since the Duration time is usually
short, a status change in the parameter Signal ON is not
visible.
Resets the selected module parameters to default value.
Table 57.
Thermo Scientific