HP MSR2000 Configuration Manual page 326

Step
1. Enter system view.
2. Configure an IPv6 static
route for an IPv6 VPN
instance.
3. (Optional.) Configure the
default preference for
IPv6 static routes.
Configuring RIPng between an MCE and a VPN site
A RIPng process belongs to the public network or a single IPv6 VPN instance. If you create a RIPng
process without binding it to an IPv6 VPN instance, the process belongs to the public network. By
configuring RIPng process-to-IPv6 VPN instance bindings on a MCE, you allow routes of different VPNs
to be exchanged between the MCE and the sites through different RIPng processes, ensuring the
separation and security of IPv6 VPN routes.
For more information about RIPng, see Layer 3—IP Routing Configuration Guide.
To configure RIPng between an MCE and a VPN site:
Step
1. Enter system view.
2. Create a RIPng process for a
VPN instance and enter RIPng
view.
3. Redistribute remote site routes
advertised by the PE.
4. (Optional.)
default cost value for the
redistributed routes.
5. Return to system view.
6. Enter interface view.
Enable RIPng on the interface.
7.
Configuring OSPFv3 between an MCE and a VPN site
An OSPFv3 process belongs to the public network or a single IPv6 VPN instance. If you create an
OSPFv3 process without binding it to an IPv6 VPN instance, the process belongs to the public network.
Command
system-view
ipv6 route-static vpn-instance s-vpn-instance-name
ipv6-address prefix-length { interface-type
interface-number [ next-hop-address ] |
nexthop-address [ public ] | vpn-instance
d-vpn-instance-name nexthop-address } [ permanent ]
[ preference preference-value ] [ tag tag-value ]
[ description description-text ]
ipv6 route-static default-preference
default-preference-value
Command
system-view
ripng [ process-id ] vpn-instance
vpn-instance-name
import-route protocol [ process-id ]
[ allow-ibgp ] [ allow-direct | cost
cost | route-policy
route-policy-name ] *
Configure the
default cost value
quit
interface interface-type
interface-number
ripng process-id enable
317
Remarks
N/A
By default, no static
route is configured.
Perform this
configuration on the
MCE. On a VPN site,
configure normal IPv6
static routes.
The default preference
for IPv6 static routes is
60.
Remarks
N/A
Perform this configuration on the
MCE. On a VPN site, configure
normal RIPng.
By default, no routes are
redistributed into RIPng.
The default value is 0.
N/A
N/A
RIPng is disabled by default.