Carbon Monoxide Detector (Sw-Att-Co) Operation - AT&T DLC-100 User Manual

Carbon Monoxide Detector Features and
Operation

Carbon Monoxide Detector (SW-ATT-CO) Operation

The Carbon Monoxide Detector (SW-ATT-CO) detects carbon monoxide only. It does
NOT detect fire, smoke, or any other gas. It gives early warning when potentially
dangerous levels of carbon monoxide exists by turning on the
sounding four (4) short beeps then silence repeating. An alarm signal is transmitted to
the DLC-100 within 15 seconds of detecting a dangerous concentration of carbon
monoxide.
NOTE: The alarm automatically resets when carbon monoxide is no longer detected.
The following are some operational characteristics of the Carbon Monoxide Detector
(SW-ATT-CO):
Operation
Status
Normal
operation
Carbon
Monoxide
alarm
Low
battery/
low
battery
hush
Alarm
end-of-life
indicator
Digital Life User Manual
LIGHT Alarm
Display Sound
Green None.
Power
LIGHT
flashes
every 30
seconds.
Red Alarm Four quick
LIGHT beeps, 5
flashes with seconds
beeps. silence,
repeating.
Red Alarm One quick
LIGHT beep every 60
flashes seconds.
every 60
seconds.
Red Alarm Two quick
LIGHT beeps every
flashes two 30 seconds.
times every
30 seconds.
|
Page 32 of 62
red light
Units Status
Normal operation
None.
with good
batteries. Not
sensing any CO.
Alarm condition.
Dangerous
concentrations of
CO detected.
Batteries need to Replace all three AA
be replaced. batteries.
Press Test/Hush button
and release. This will
silence the low battery
audible chirp between 8
and 11 hours allowing for
a more convenient time to
replace the batteries.
End of CO Alarm Press the Test/Hush
life. button and release. This
will silence the end-of-life
signal for up to three days.
After three days, the unit
will resume end-of-life
chirps. Hush mode will
silence the alarm ten times
or up to 30 days. After 30
days, the unit can no
longer be hushed. Replace
the CO Alarm immediately.
The unit will not respond to
CO.
indicator and
Recommendation
ATT-UM-V1.1-201303