GE VersaPoint IC220PBI002 User Manual page 119

Specifying the Active Configuration
1. Specify the address on the station using DIP switches 1 to 7 and select
the operating mode using DIP switch 8 = ON.
Connect the modules that represent the subgroup of the maximum
configuration. In the hardware configurator, configure only the "PD-PCP
x words" module (recommendation: x > = 8).
The address can be freely defined in the PLC memory within the
framework of the options provided by the PLC. The module has no
specific requirements.
2. Specify the active configuration.
In the example, the modules in slots 3, 4, and 6 should be deactivated.
According to the description of index 6, the value is 2C 00 00 00 00 00
00 00.
Write request (master -> slave)
Data (8 Words VC1)
04 00 00 06 00 08
00 00 00 00 00 I 00 00
Write response (slave -> master)
Data (8 Words VC1)
84 00 I 00 00 00 0
00 00 00 00 00 00 00
Clear request (master -> slave)
Data (8 Words VC1)
00 xx xx xx xx xx xx xx xx xx
xx xx xx xx xx xx
Clear response (slave -> master)
Data (8 Words VC1)
00 00 00 00 00 00 00 00 00 00
00 00 00 00 00 00
GFK-1911B Chapter 7 Configuration
Data Structure
Write/Slot/Index high/Index
2C 00 00
low/Subind
Data Structure
Write re
0 00 00 00 sponse/Status I 14 bytes unused
Data Structure
Clear
Data Structure
Clear response
ex/Length/Data I 2 bytes unused
7
7-19