Raymarine Raystar 125 Owner's Handbook Manual
  1. Manuals
  2. Brands
  3. Raymarine Manuals
  4. GPS
  5. NMEA 0183
  6. Owner's handbook manual

Raymarine Raystar 125 Owner's Handbook Manual

Raymarine gps receiver owner's handbook 125
Hide thumbs
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Raystar 125 GPS Receiver
Owner's Handbook
Welcome to the Raystar RS125 GPS Receiver
What's in the box?....
Part No: R38103
Raystar RS125 GPS Receiver
Flush mount gasket
The Raystar RS125 GPS Receiver has no user serviceable parts.
What tools do I need to install it?....
Drill
6mm (
Drill bit
Your handbook contains an explanation of how to install,
operate and maintain your Raystar RS125 GPS Receiver.
Intended Use
This product is a GPS antenna with a built-in position
fixing receiver using either NMEA0183 (Version 2.3 or
later), or Raymarine SeaTalk data output. The intended
application is for leisure marine boats and workboats not
covered by IMO/SOLAS carriage requirements.
Part No: E35018
Pole mount kit
Studs (x2)
20mm (
13
/
1
/
in)
16
4
Drill bit
www.raymarine.com
Part No: R38104
10m (33ft) NMEA/SeaTalk
connection cable
Thumb nuts (x2)
connectors (x5)
Screws (x2)
in)
Phillips
screwdriver
1
3- way
TM
Scotchlok
Adhesive tape

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Raystar 125 and is the answer not in the manual?

Questions and answers

Related Manuals for Raymarine Raystar 125

Summary of Contents for Raymarine Raystar 125

  • Page 1 This product is a GPS antenna with a built-in position fixing receiver using either NMEA0183 (Version 2.3 or later), or Raymarine SeaTalk data output. The intended application is for leisure marine boats and workboats not covered by IMO/SOLAS carriage requirements.

  • Page 2: Safety Notices

    Where can I install the unit?... Pole mount Radar Above the beam In the beam Below the beam Clear view of the sky RS125 GPS Receiver Flush Rail mount mount No trip or tread Top of the mast VHF Radio and other antenna...
  • Page 3 To mount the unit on a pole... To flush mount the unit... Securely attach the pole mount base to a suitable pole. Pass the cable and connector through either the center of the pole mount bracket and the pole, or the cable exit hole alongside the center hole.

  • Page 4: To Connect Rs125 Using Scotchlok Connectors

    If you do not have a breaker in the power circuit, an in-line 0.5 A quick blow fuse should be fitted to the positive (red) lead of the cable. RS125 GPS Receiver Using suitable wire clippers, remove the tinned ends from the individual cables. Leave the insulation intact.

  • Page 5: Connect To C-Series/E-Series Display

    C-Series SeaTalk pigtail to the GPS receiver or overall SeaTalk network. If you are not using a land-based DGPS antenna on your Raystar 125 GPS receiver (most installations do not), you should connect the brown RTCM input to the shield wire (ground).
  • Page 6 You can obtain the following accessories to help you quickly and easily connect your RS125 to existing equipment: E36013 - 600mm Antenna conversion cable E36014 - 1000mm Display conversion cable RS125 GPS Receiver Flashing RED Unit is in bootcode, either being upgraded or unable to boot.

  • Page 7: Emc Conformance

    For full details of their licensing agreement refer to our website at www.raymarine.com Warranty To register your new Raymarine product, please take a few minutes to fill out the warranty card. It is important that you complete the owner information and return the card to us to receive full warranty benefits.

  • Page 8: Product Repair And Service

    (603) -881-5200 (603) -881-5200 (603) -881-5200 Product Repair and Service Product Repair and Service Product Repair and Service Raymarine Product Repair Center Raymarine Product Repair Center Raymarine Product Repair Center 21 Manchester Street, 21 Manchester Street, 21 Manchester Street, Merrimack, NH 03054 - 4801...

This manual is also suitable for:

Nmea 0183

Table of Contents

Save PDF