Setting The Bus [Bus]; Setting The Audio Faders - Panasonic AG-HMX100P Operating Instructions Manual

When the 3D mode is [OFF] (  page Vol.2-25), the system
format of this unit is the one set in the [VIDEO FORMAT]
submenu of the [SETUP] menu. When the 3D mode is other
than [OFF], the system format of this unit is the one set
under the [3DFORMAT] item in the [3D] submenu of the
[SETUP] menu.

Setting the Bus [BUS]

The [BUS] submenu of the [SETUP] menu is used to set the
output method of this unit to either of the following:
AB bus system: Switches between video A and video B.
bus source selector button corresponding to the source
used for the transition pattern and output from a PGM
source that you want to display next can be selected only
 For more information about the input source selection
operation, see page 33.
Rotary 1 Rotary 2 Rotary 3
BUS TYPE
AB
AB
PRG/PRE
The factory default setting is [AB].
Setting Audio Channels [AUDIO CH]
channels 1 to 8 can be assigned. When the system format
Rotary 1 Rotary 2 Rotary 3
AUDIO CH L-CH
CH SDI1
SDI1 1-8 (1-4)
SDI2
SDI3
SDI4
1
Set [CH] to one of [SDI1], [SDI2], [SDI3], or
[SDI4] (SDI inputs 1 to 4) using the rotary 2
control.
Rotary 4 Rotary 5

Rotary 4 Rotary 5
R-CH OSD
1 2 ON
1-8 (1-4) OFF
ON
2
Use the rotary 3 control to select the audio
input (of the SDI input selected in Step 1) which
you want to assign the L channel by setting
[L-CH] to the desired audio input number.
3
Use the rotary 4 control to select the audio
input (of the SDI input selected in Step 1) which
you want to assign the R channel by setting
[R-CH] to the desired audio input number.
4
Repeat Steps 1 to 3 to assign each audio
input of SDI inputs 1 to 4 to the L channel or R
channel.
 NOTE
The set channel is stored in memory separately between the
cases in which the system format is SD and HD ( page 19),
and is called according to the format when the system format
is changed.
To hide the audio level meter during
multi-view output
The factory default setting is [ON], in which the audio level
meter is displayed when the multi-view output is monitored.

Setting the Audio Faders

[AUDIO FADER]
When adjusting the audio level of input sources 5 to 8,
operate the corresponding fader while holding down the
the MIC fader to adjust the MIC input level.
[SETUP] menu.
Rotary 1 Rotary 2 Rotary 3
AUDIO SOURCE AUX/MIC
FADER BUS SEP1
CP PAIR PAIR
BUS SEP1 SEPA.
BUS SEP2
12 PAIR
12 SEPA.
Rotary 4 Rotary 5
PAIR
27