Whirlpool 8LIECH-SC-SSS-5L-W User Manual page 19

8LIECH-SC-SSS-5L-W
Q20. The buttons for dispensing water are slow-moving or jammed.
Ensure that buttons are clean and no dust or particles are causing buttons to move slowly.
Q21. Dispenser is not operating.
Make sure that the power cord is properly connected to a working outlet.
Q22. Water is leaking.
Replace water bottle. The most common cause of this issue is a cracked bottle. If the leak
remains, unplug unit and call 1-855-594-4755 for assistance (Bottles do crack. Water
companies replace polycarbonate bottles after 30 cycles of use.).
Q23. No water is coming from the taps.
• Make sure the water bottle is not empty. If it is, replace it. If not, adjust the probe to
an appropriate length.
• Make sure that the controls have been fully activated.
• Make sure that the probe connection with the water bottle forms a complete seal.
• Make sure that the door is closed.
Q24. Water dispensed is not cold.
• Please note that it takes a minimum of one hour after setup to dispense cold water.
• Make sure that the back of the dispenser is at least 4 inches from a wall and that
air is free to flow on all 4 sides of the dispenser.
• Make sure that the cold-water switch is ON.
Q25. Water dispensed is not hot.
• Please note that it takes approximately fifteen to twenty minutes after setup to
dispense hot water.
• Make sure that the power cord is properly connected to a working outlet.
• Make sure that the hot-water switch is ON.
Q26. Empty bottle LED light is flashing.
Replace the empty bottle. If you cannot replace the empty bottle immediately, leave the
door ajar or unplug the cooler to stop the flashing lights.
P a g e 1 7