Descaling Procedure; Led Indicator Lights - Whirlpool 8LIECH-SC-SSS-5L-W User Manual

8LIECH-SC-SSS-5L-W
• For descaling less frequently than once a year, use undiluted white vinegar.

Descaling Procedure

1. Fill a bucket or empty 5-gallon water bottle with solution of white vinegar. For
proportions, refer to the instructions above. Choose quantity in accordance with the
frequency of your treatments.
2. Attach or insert the probe to the bucket/bottle.
3. Place the bucket/bottle into the cooler and close the door. The water will be pumped up
into the holding tanks.
4. Plug in the cooler and turn on the hot switch located at the back of the cooler. Do not
turn on the cold-water switch.
5. Wait for 1 hour.
6. Unplug the cooler from the wall
7. Using rear drain plug, drain the water from the cooler into a bucket and discard the
water.
a. Locate the white plastic cap at the back of the cooler.
b. Remove the screw.
c. Remove the clear silicone drain plug and allow water to drain out.
d. Re-attach the drain plug and plastic cap before proceeding.
e. Fill the bucket/bottle with tap water and place into the machine.
8. Plug the cooler back into the wall, close the door and wait for 10 minutes.
9. Dispense water from both cold and hot faucets until smell from cleaning substances
disappears.
10. Open drain plug and cap once again and drain all tap water.
11. Replace the drain plug and cap.
12. Place a fresh bottle of water into the machine and operate as usual.
13. This procedure must be repeated every 3 to 6 months, depending on mineral content
and usage of water cooler.

LED INDICATOR LIGHTS

POWER INDICATOR (1)
When the LED light is constantly lit it indicates that power is being supplied to the unit.
HEATER INDICATOR (2)
P a g e 1 3