Reset Button - Mitsubishi Electric MAC-568 User Manual

Wi-Fi Interface Overview
Current compatible Mitsubishi Electric Wi-Fi Interfaces:
MAC-568IF-E, MAC-559IF-E and MAC-558IF-E.

Reset Button

The Mitsubishi Electric Wi-Fi Interface has a reset button if
you wish to reset the device and make a new connection
to your router. More information can be found in the Wi-Fi
Interface Installation Guide which came with your Wi-Fi
Interface, and is available to download on the Wi-Fi Control
App.
Wi-Fi Interface LEDs
MAC-568: The Mitsubishi Electric Wi-Fi Interface has 6 LED
lights to indicate operation and status, which can be used
to diagnose whether there is a problem with connection.
More information can be found in the Wi-Fi Installation Guide
which came with your Wi-Fi Interface, and is available to
download on the Wi-Fi Control App. If the installation has
been completed successfully you should see MODE LED
flashing orange every 5 seconds and the UNIT LED lit up
green on the Wi-Fi Interface.
MAC-558/559: The Mitsubishi Electric Wi-Fi Interface has 3
LED lights to indicate operation and status, and can be used
to diagnose whether there is problem with connection. More
information can be found in the Wi-Fi Interface Installation
Guide. If the installation has been completed successfully
you should see LED1 and LED3 on the Wi-Fi Interface
flashing in sequence approximately every 5 seconds.
MAC Address/ID Number
MAC-568: If your MAC-568 Wi-Fi Interface has been
successfully connected to your smartphone/tablet, the MAC
Address/ID Number will populate in the Wi-Fi Control App
automatically.
MAC-558/559: To register a system on the Wi-Fi Heat Pump
Control, you will need the MAC Address and ID Number
from the Mitsubishi Electric Wi-Fi Interface, located in the
Mitsubishi Electric Wi-Fi Interface box. This should also have
been recorded on page 2 of the Wi-Fi Interface Installation
Guide.
6 6
Important
The Mitsubishi Electric Wi-Fi Interface is designed for
communication to the Mitsubishi Electric Wi-Fi Heat Pump
Control service. The unauthorised use and redistribution
of the firmware of the Mitsubishi Electric Wi-Fi Interface
is strictly prohibited. Use of a Wi-Fi Interface is therefore
deemed as confirmation that the user has accepted this
statement. Third party Wi-Fi Interfaces cannot be connected
to the Wi-Fi Heat Pump Control service. Mitsubishi Electric is
not responsible for any (i) under performance of a system or
product; (ii) system or product fault; or (iii) loss or damage
to any system or product; which is caused by or arises from
connection to and / or use of any third party Wi-Fi Interface
or any third party Wi-Fi service with Mitsubishi Electric
equipment.
MAC-568
MAC-558/559