Sd Card Management - Foscam FI9903P User Manual

Connect the external power adapter, request for 12V / 2A or 12V / 1A power.
5 Audio input interface (Except FI9803EP / FI9803P / FI9903P)
The jack is used to plug external input device such as sound pick up device directly. Here microphone cannot
directly insert to the interface, it must connect to adapter first.
6 Audio output interface (Except FI9803EP / FI9803P / FI9903P)
The jack is used to plug external output device such as loud speaker directly. Here microphone cannot directly
insert to the interface, it must connect to adapter first.
7 RS485 Cradle head interface (Only forFI9805E)
This camera supports the standard 485 cradle head protocol (Pelco-D and Pelco-P). Please configure the
RS485 protocol corresponding information first (go to Settings- PTZ - RS485 Configuration page and do
settings), or else the cradle head may cannot work.
1.5.3 Bottom View
There are up to two labels located at the bottom of the camera, this is an important feature of original Foscam
cameras. If your camera does not have labels, it may be a clone. Cloned Foscam cameras can not use original
firmware and are not eligible for warranty or technical services.

1.6 SD Card Management

The record files of the IPC can be stored in the SD Card.
You need open the IP Camera, then plug the SD card into SD card slot inside the IP Camera.
When you plug in the SD card during the camera work process, please reboot the camera again, or else the
SD Card may be cannot work well.
Insert Micro SD Card in the location shown below.
FI9803EP
6