Determining The Wwns World Wide Names - Quantum Tape Drive Scalar 50 Installation Instructions Manual

Determining the
WWNs World Wide
0
Names
Table 3 Library World
Wide Names
•

Determining the WWNs World Wide Names

• Verifying Library Connectivity
The media changer (robot) and tape drives within the library have WWNs
World Wide Names assigned to them by the system controller board (SCB).
The WWNs must be determined and recorded both for the customer and for
Quantum customer support. This information is important when replacing
the Fibre Channel SCB and tape drives. Using the following procedures,
complete table 3 and retain a copy of the table for your records. Have this
table available when contacting Quantum Customer Support for any library
or tape drive connectivity issues.
Library/Tape Drive
Media Changer
(robot)
Tape drive 1
Tape drive 2
Tape drive 3
Tape drive 4
Using the Remote Management to Determine the WWNs
To determine the WWNs from the library remote management pages:
1 On the host computer, open the internet browser software.
2 In the field, type http://IPaddress/ where IP address is the IP
Address
address for the Quantum Scalar 50 series library.
3 Enter the username and password and click
Note: The default username and password is
The page displays (see
Overview
Completing the Native Fibre Channel Installation
Quantum Scalar 50 Tape Drive Installation Instructions
World Wide Name (e.g. 50:05:08:40:00:16:47:00)
OK
figure 16):
Document 81-81769-01 B01
September 2007
.
.
admin
0
15