Battery Box Removal/Installation; Assembly/Disassembly - Pride Mobility Jazzy Passport Owner's Manual

Initial Assembly
Your power chair may require some assembly either before initial use or after transportation. It may also
require disassembly to make some comfort adjustments.
NOTE: Any nylon insert lock nut removed during the disassembly or adjustment of the power
chair must be replaced with a new nut. Nylon insert lock nuts should not be reused as it may
cause damage to the nylon insert, resulting in a less secure fit. Replacement nylon insert lock
nuts are available at local hardware stores or through your authorized Pride Provider.
To assemble your power chair:
1. Unfold the power chair assembly. See "Folding and Unfolding."
2. Install the battery box into the battery tray by sliding it horizontally into the rear of the frame beneath
the seat until the securement pin clicks into place. See figure 4.
3. Flip up the armrests.
4. Insert the controller into the armrest and tighten the thumbscrew, then latch the quick release handle.
See figure 5. Hook the controller harness to the securement clips. See figure 9.
5. Insert the cup holder into the other armrest and tighten the thumbscrew, then latch the quick release
handle.
6. Attach the cushion and seatback cover to the chair by securing the reusable hook and loop fasteners
together.
7. Remove the battery charger from the box and plug into the controller charger port. Follow the charging
instructions printed on the charger. See figure 12.
Figure 4. Battery Box Removal/Installation

Assembly/Disassembly

11