Firmware Update; Update Through Memory Card; Declaration Of Conformity - GRAUPNER mc-32 HoTT Manual

Firmware update

Declaration of conformity

Update through memory card

33032_jp_V1
The programs and files which are also required for updating the
transmitter combined into one software package can be down-
loaded from www.graupner.de.
Download this software package from the Internet, and unpack
it on your computer. All other information can be found in inter-
net in the same page where the software package is available.
Firmware updates of the transmitter can be performed in two
ways.
 Update through memory card
 Update through USB port
Note
Please note that compatible firmware is required for reliable

communication between the HoTT components. The programs
and files that are required to update are therefore combined into
a single file.
The current firmware version can be found on the Internet at

www.graupner.de.
Only operate your transmitter using the current software version.

these information can also be found at: www.graupner.de =>
Service & Support => Update and revision history for GRAUPNER
HoTT components.
Before each update, check the transmitter battery charge or

charge it as a precaution, and save all model memories so that
they can be restored if necessary.
33032 mc-32 HoTT
Do not disconnect the link to the computer during an update!

Graupner/SJ declares that the product is conform to EU norms.
Make sure that the link between the transmitter and computer is
operational.
EMV 2004/108/EC:
After each update, check to make sure that the models function

EN 301 489-1 V1.9.2
correctly.
EN 301 489-17 V2.1.1
EN 62479:2010
Download the actual software package from the Internet, and
LVD 2006/95/EC:
unpack it on your computer. Insert the supplied mini SD Card in
EN 60950-1 + A11 + A1 + A12 + A2:2013
the card slot of your PC and copy the required firmware file from
the unpacked software package into the directory „Firmware"
R&TTE 1999/5/EC:
on the memory card. Then, remove the memory card from the
EN 300 328 V1.8.1
PC and insert it in the card slot of the transmitter. Switch on the
EN 62311:2008
transmitter and the RF module off.
Go to the submenu "FIRMWARE UPDATE" in the menu "Hidden
mode" and proceed as described in the "Hidden mode" section.
33 / 36